So peeps. I have a room with a few lights that I’m currently in veg 18/6. Last week I turned on my last two lights. Everything is connected to a controller. Come to find out the last two were not. It’s been close to a week that these two lights were running 24/0 and the other 6 were 18/6. I...
I will tomorrow but yea. I think I might need to toss them. I used separate scissors for them and every other strain is not showcasing any symptoms.
As long as I didn’t use the same tools, will the other plants be ok.
They have touched each other not sure if it can transmit that way
So I picked up 23 plants from a breeder. Ask them numerous questions in regards to ipm and viroid testing. They reassured me all is well and they are thorough.
7 pure Michigans look suspect of the hop virus. I topped them today with a separate pair of scissors and have them in a corner of the...
So I took some cuttings off my plant third day of flower like I normally do. I put them in the cloner and two weeks later I had roots and potted them.
I noticed on the edge of the leaves a white fuzz looks like trichomes but how can that be when I took the cuttings third day of the flip. I’ve...
I had a mysterious bad two years that I attributed to micro root aphids. Never did see them tho. At one point I thought my room was infected a mysterious fungi or virus. After numerous applications of bleach, hydrogen peroxide and white vinegar and no improvement.
Post some pics
Yes. I finished out a few months ago. Great run to be honest. Green and luscious throughout the run.
check the intensity of your leds. I start off at 40 percent and gradually increase
check your co2 levels. I didn’t have co2 turned on. I guess my area just had an excess of it somehow. 1500...
As the title states. What are some characteristics that would a plant would display in veg and flower?
Will the plant still stretch in flower?
So far I’ve noticed brittle branches, tight nodes, smaller plants and leaves
Does this plant look like it is infected?
Idk if it’s genetics but it...
Nope. I checked for a dead animal everywhere. Took the sensor outside it immediately dropped to 450. Grabbed a new sensor reading 1500 anywhere I put it.
been giving me a slight headache. But I’m more concerned with where’s its coming from
What cause high ppms of co2 1500 plus with no burner or tank?
some details. Sealed room
burner is unplugged.
gas line is shut off.
6 lights
Multiple fans
Furnace is not running
Room reads 1500 plus
Outside of room reads 1500 plus
Kinda stumped here. What would contribute to high ppms...