T
TwisTer46290
- 41
- 8
Hey guys! I'm trying to understand why my shatter is starting to phase change and maybe some advice on what I should do?
I have two chambers on silicon mats with a pid. One set @ 96.9 and the paddy is 90ish, the other @ 103 and the paddy is the same. They've been purging for about a week +/- and I've been fliping them a couple times a day, then purging back to a little less than one bar (Not continuous, vac and pull). I freeze them inorder to flip them. I've noticed over the past two days they've started to look as if they're going to sugar or honeycomb on me. They came from the same harvest which was a low THC Chemdog.
I know high temps, terps, or agitation can cause this, but I don't believe they've played a roll.
What do you think?
Thank you very much in advance!
I have two chambers on silicon mats with a pid. One set @ 96.9 and the paddy is 90ish, the other @ 103 and the paddy is the same. They've been purging for about a week +/- and I've been fliping them a couple times a day, then purging back to a little less than one bar (Not continuous, vac and pull). I freeze them inorder to flip them. I've noticed over the past two days they've started to look as if they're going to sugar or honeycomb on me. They came from the same harvest which was a low THC Chemdog.
I know high temps, terps, or agitation can cause this, but I don't believe they've played a roll.
What do you think?
Thank you very much in advance!