This guide will walk you through the process of connecting your In-Line Duct Fan to a 110/120 Volt AC, 60Hz power source using a heavy-duty extension cord. Following these instructions will ensure proper function and safety for your fan.
Power Source Requirements
To guarantee the correct operation and safety of your In-Line Duct Fan, it must be connected to a 110/120 Volt AC, 60Hz power source, either fused or protected by a 15-amp circuit breaker. Do not connect the fan to a 240 Volt AC blower motor or any other 240 Volt system.Connecting the Fan to an Extension Cord
Upon unboxing the fan, you may notice the absence of a wire cover box. This is because the cover box is only required when connecting the fan to a switch. For this guide, we will connect the fan to a heavy-duty extension cord.Wire Identification and Connection
Your fan should come with the following wires:- Black wire
- Green wire (ground)
- White wire
Safe Wiring Practices
For safe wiring, you will need a wire-stripper-crimper tool with the following features:- Point A (white arrow): Cuts wire ends, similar to a pair of pliers. Most wires are pre-cut by the manufacturer, so this step may not be necessary.
- Point B: Strips the wire by inserting the wire end into the appropriate gauge hole (indicated on the tool) and pulling.
- Point C: Crimps the wire. In this guide, we will use wire nuts instead of crimped butt splice connectors.
Important Safety Note: Never leave any bare wires exposed!
Final Steps
With the wiring complete, plug the fan into an outlet. If you are hanging the In-Line Duct Fan, ensure that it is adequately supported. If you are installing the fan within a wall, wrap rubber around it to minimize noise and prevent vibration.Warning: Never expose your In-Line Duct Fan to temperatures exceeding 140°F (60°C) to avoid damage or malfunction.