Search results for query: *

Im ditching my Rev Micro DEVA lights. they do not hold up in a room with high humidity and possible water vapor condensing on the fixture. the PCB will short out or get hard water residue on it and cause them not to work. just a result of having a PCB fully exposed to the grow room environment...

@heisen what happened to your 1000w cmh vs cob thread?

Bump on the triminator versus trim pal I'm selling my greenbroz unit as it turns all of my colas into Smalls. I've read that the triminator has a smaller diameter tube thus the tumbling action is more gentle on the Buds versus the trim pal that has a further drop for the buds to travel and crash...

I've got a greenbroz here and I'm not happy with it the stems get caught in the blades and the brush in combination turns your nugs into Smalls it cakes up way too fast and gets hash between the two blades and stops functioning properly I'm looking to switch to a triminator dry does anyone have...

Maybe the bulb doesn't work well unless it sees 260 hurts

check out mangotech and the trolmaster stuff

I've got four Revolution micro Deva 1 kilowatt de lights in a 10 x 10 tent

has anyone gotten full spectrum extracts (winterized at -25f) to stabilize in PG? i have separation after about 3 weeks in a vape cart. is my winterization too warm to pull out all the waxes?

literature says 200-260v 260hz is what the LFSW CMH ballast outputs, this lamp is designed to work with this ballast. My Rev Micro DEVA is 100hz 400v output probably wouldnt work with these CMH lamps I cannot find the voltage and hz output of the Sunplix ballasts... what ballast do you have?

I do dry trim. It takes me about 7-8 hours to trim 1 lb. Which right now equates to about 3lbs a week max I'm able to get through myself so in essence it's taking me more time to trim and finish before the next run is ready

I'd be interested to see your de hps log and compare it to the cmh. I've got a line on 12 nanolux de hps lights cheap

Your cob setup is titties. If I had the money and dedication to outfit my next build with them I would.

If I had the time and ability to build enough cobs or qb's to outfit a 20x30 I'd do it

Thanks for the heads up I don't think 24" to the canopy was doable after all. Seems it needs to be the same as a 1kw DE at 36-40 in spacing

if you look at rosin id look at crd.inc on IG they make cheap drip tech units, you could batch squish preloaded ingots and drip it straight onto a platter without cleaning between presses

Anyone have experience with these? i have a smaller op but 15-20lbs every 1.5 mos or so and im unable to keep up with trimming by hand. its getting to be too much. how do you guys like your GreenBroz units?

why do you have to use butane? there are better methods of extraction for keif. checkout future4200 I would get a couple gallons of everclear or 710spirits. throw it in a bucket with a paint mixer drill attachment stir it like crazy for 5-10 mins then filter it using a panda spin dryer and...

I like the idea of using these CMH lights in an 8' ceiling room roughly 15'x30' as they can have the canopy closer to the bulb versus DE HPS 1kw lights. Would you say then that you disagree with the below comments (comparing Gavita 1kw to DE CMH)?

Are you saying all 1000w DE dual arc tube CMH bulbs on the market are using these same 450w TOTO burners? Nanolux has a 1000w DE CMH. is theirs the same?

There are a few low freq. Square wave hps ballasts out there. Revolution micro Deva. Will they effectively run these nanolux bulbs?