Recent content by nice.plugin

4.0....?

you have learned well young grasshopper

if the branches are extending past the light, they are not getting light, which means no bud growth being gentle, very gentle, bend back using LST as to get the plant back into the light without it being too close so that it burns

if plants are being fed proper nutrients in DWC systems, they are intaking enough food to build stable branches and do not require the use of trellis systems. With true sativas a support system might be needed in DWC, but im sure that if the branches were trained during the veg cycle to be...

day...'x'... flowering?

finally starting to look like a garden :-p and see you got the dehumidifier in there, good move. still, 60% is too high for flowering, as you run the risk of bud mold exceeding 50-55%; 45 is ideal. have you noticed any spider mite resurgence since flowering began? Also, now that you are...

1) where on the plant were these leaves located 2) can you take a picture of the affected leaves while they are still on the plant 3) have you noticed any discolorations or pH / ppm fluctuations in the last few days? also, the plants are starting to compete for light. if you feel confident...

the bottom section of the bushier shrubs look like they need some trimming to allow air to flow from the bottom up

While RDWC systems seem ideal, single systems are the best for the following reasons; 1) single systems allow for more precise nutrient control when you start to fine tune the solutions for each week of its growing cycle 2) in RDWC systems, space can become an issue since the plants are...

Good to see things are perking up, one piece of advice though; try to get the pH down to 5.3-5.5, allowing it to fluctuate up to 5.7-5.9 but keeping it within that range. Now that the water is lowered and your plants can process more food, your water level will drop since they are pulling up...

Hey kritical, if you get the chance, can you take a few pictures of the grow buckets without the covering on them if the water temp is not an issue? Also, what is the ppm of the R/O water without nutrient solution? I think you have done a splendid job :) but I can tell at this point that you...