Colloidal Silver Fully Explained

  • Thread starter Seraphim19
  • Start date
  • Tagged users None
S

Seraphim19

250
93
How to make a colloidal silver generator for £10 I just wanted to share this knowledge with you and give a little back.

I will now give you step by step instructions on how to make a colloidal silver generator and how to produce the silver itself

First you will need the components:
Colloidal silver fully explained


1. a multimeter ( got mine off ebay for £2 ) this is to measure the current passing throught the water
Colloidal silver fully explained 2


2. a 33Kohm 0.25W resistor ( from any good electronics supplier for pennies )
Colloidal silver fully explained 3


3. 4 9v batteries ( got them for £2 at the supermarket )
Colloidal silver fully explained 4

4. pure silver not jewelelry it has to be 99.99% pure (got pure silver wire from ebay £3 )
Colloidal silver fully explained 5


5. pure water the purer the better (NOT TAP WATER!!)distilled or de-ionised
Colloidal silver fully explained 6


6. 3 double ended crocodile clips
Colloidal silver fully explained 7


7. a clean glass vase (cleaner than this one)
Colloidal silver fully explained 8


Now to assemble the generator

1. connect all 4 batteries together creating a 36v power supply
Colloidal silver fully explained 9


2. wrap one end of the resistor to each of the prongs from the multimeter
Colloidal silver fully explained 10

Colloidal silver fully explained 11

3. connecting the clips
a. connect two clips to the batteries one on each free pole
Colloidal silver fully explained 12


b. now get the multimeter and attach the third clip to one prong
c. then attach a clip from the battery to the other prong on the multi meter
Colloidal silver fully explained 13


d. now take some silver wire and put a good length in each free clip

4. turn the multimeter on and touch the silver wire together to test. it should say 36v

5. now place the silver wire into the pure water on opposite sides of the container, making sure the clips do not touch the water only the silver(ruins the solution)

to make sure I don't touch anything with the silver I use a diy holder for the clips.

Here is my method

I get a piece of cardboard, some sticky tape, scissors and a measuring tape.
Colloidal silver fully explained 14

I measured how wide the vase is and made holes in the cardboard so the wires could drop into the water about an inch apart

Then I taped the clips to the cardboard and made sure the wire did not touch the sides
Colloidal silver fully explained 15


then just sit it on top of the vase
Colloidal silver fully explained 17
Colloidal silver fully explained 16


TIP: use a clean glass container to make the colloidal silver in, as glass is inert and will not affect the solution

Now you should see the voltage is lower than 36v this is normal as the water is not as conductive yet. as time passes the voltage will rise.
Colloidal silver fully explained 18


It should now look something like this
Colloidal silver fully explained 19
Colloidal silver fully explained 20


leave this to work for about 8 hours the water will yellow slightly as soon as you see this stop the generator its done!

To effectively use this solution
spray female plants once daily (drenching)

start spraying as soon as they show pistills

within two weeks you should see male heads start to form, when this happens stop spraying with colloidal silver and return to normal growing strategies.

you should have viable fem pollen after 4 weeks of stopping the spraying

as per timeline below

week 1 plant germs

week 3 pistills appear and spraying with colloidal silver starts

week 5 male heads developing spraying stops

week 8-9 Fem pollen released

This generator has produced me multiple batches of cs and they have all worked 100%

Any questions feel free to contact me as I will be only too glad to assist you
 
north knect

north knect

1,203
163
@north knect here you go mate let me know if you have any questions
Thanks bud ur the man!!! So I have some 99.2 silver wire for soldering necklaces..I'm guessing this isn't pure enough?..this thread is gunna blow up lol..can't thank u enough :D
 
S

Seraphim19

250
93
@north knect
You are correct mate you need 99.99% pure silver for this. You can find 99.99% pure silver wire easily on ebay or alternatively try a specialist dj/music equipment shop as pure silver is used for wiring to achieve the best sound quality.
 
north knect

north knect

1,203
163
@north knect
You are correct mate you need 99.99% pure silver for this. You can find 99.99% pure silver wire easily on ebay or alternatively try a specialist dj/music equipment shop as pure silver is used for wiring to achieve the best sound quality.

Thx bud I will ask around the guys..I'm quote musically inclined and kno a lot of guys who own the instrument shops around..I'm sure il find it if not the bay it is
 
H

happy b

Guest
Great thread and info seraphim.Any pics of the offspring youv grown to maturity ?iv seen a few journals about making fem beans but never seen a journal were they tested the beans they made and documented it for others . that's what I'd like to see . The end result .The whole process too the final outcome.
 
S

Seraphim19

250
93
Ok back with more info as I did say FULLY explained.

In this part I will be going through what colloidal silver is and how to use it with autos to make feminised seeds.

I hope that this guide will be beneficial for those wanting to try their hand at feminisation for the first time.

What is Colloidal Silver?


First lets break it down.

A Colloid is a substance in which microscopically dispersed insoluble particles are suspended throughout another substance.
In this case the colloid will be pure water. The microscopically dispersed substance in this case will be pure silver.

Once the microscopic particles have been suspended in the water it is known as colloidal silver

What is Colloidal Silver used for?

Colloidal Silver has a number of uses and is sold for medical purposes, but in this case we will be using it to give a plant a sex change.

How Does it work?
When used to reverse a plant the microscopic particles of silver will penetrate into the plant and begin to stop the production of ethylene. By stopping ethylene production the plant will produce male flowers. These flowers and the resulting pollen, although male in appearance, do not posses the Y chromosome found in male plants.
So by using pollen containing only X chromosomes you will create all female seeds.
the reason for this is that the plant that will bear the seeds will be female containing XX chromosomes and the pollinating plant will also be female containing XX chromosomes. This means each parent can only pass on an X chromosome to the next generations, so all will have XX chromosomes which will make them all female.

How do I get some Colloidal Silver
There are two ways to get some colloidal silver, either buy some or make some.
I recommend that you make some. The reason for this is that you will know that your C.S. is fresh and the right concentration.
There are a few products on the market claiming to be able to reverse a plant but I have not found one that I could recommend.

How do I make feminised seeds using autoflowering plants
To make feminised seeds with autos is easy IF you get your timing right. The key is to have the mother plant at the right stage to accept pollen when the reversed plant is ready to drop pollen.
The rule you want to follow is that the mother plant should be put down 2-3 weeks after the plant to be reversed. So if you had a strain you loved i.e. AK47 and wanted to make a supply of fem seeds you would plant one today and another in 2-3 weeks. This should mean that the reversed plant will drop pollen around week 8 of its life and the mother plant should be ready to accept the pollen at 5-6 weeks old, allowing time for the seeds to mature fully and allowing the mother plant to develop enough buds to give you a lot of seeds.
 
S

Seraphim19

250
93
Great thread and info seraphim.Any pics of the offspring youv grown to maturity ?iv seen a few journals about making fem beans but never seen a journal were they tested the beans they made and documented it for others . that's what I'd like to see . The end result .The whole process too the final outcome.
hey happy
I haven't got any pics of my production runs but I am about to start one in the next couple of weeks so I will post a journal for you once I get going, and I will even follow it up with a grow off between myself and a few of my buddies, so we can see the end results of the feminising process.
 
Full.Melt

Full.Melt

204
63
i've been making this stuff for 2 years.good tutorial @Seraphim19.did you check the ppm of the final solution? my stuff usually comes out at 11-15 ppm.i heard that wasn't high enough ppm for it to work.but it works fantastic every time.made a few hundred plushberry s1's that i still grow out.
 
H

happy b

Guest
hey happy
I haven't got any pics of my production runs but I am about to start one in the next couple of weeks so I will post a journal for you once I get going, and I will even follow it up with a grow off between myself and a few of my buddies, so we can see the end results of the feminising process.
Sounds like a superb idea buddy and i look forward to it . iv been wanting to do some reversals for a while but had never seen a journal on a method done right to the end which made me suspect that the resultant offspring from the seeds made in those journals didn't turn out the way they had anticipated them to turn out so I never ever bothered doing it . But if your showing me it being done from start to finish I may giv it a go . I like how you,v even told us were to get the equipment needed.
 
H

happy b

Guest
i've been making this stuff for 2 years.good tutorial @Seraphim19.did you check the ppm of the final solution? my stuff usually comes out at 11-15 ppm.i heard that wasn't high enough ppm for it to work.but it works fantastic every time.made a few hundred plushberry s1's that i still grow out.
Do any of yours ever produce more nanners than your average fem seed?or are they just as good sexual stability wise?
 
S

Seraphim19

250
93
i've been making this stuff for 2 years.good tutorial @Seraphim19.did you check the ppm of the final solution? my stuff usually comes out at 11-15 ppm.i heard that wasn't high enough ppm for it to work.but it works fantastic every time.made a few hundred plushberry s1's that i still grow out.
yes I do check the ppm mine usually is around 30-40 ppm. you can use a weaker concentration but if you are like me and forget to spray occasionally then the higher concentration gives better results.
For lower concentrations it is recommended to spray twice daily and with the higher concentration just once a day, so I stick with the strong stuff
 
H

happy b

Guest
Iv gotta try this . iv got loads of strains I would love to reverse . But iv been saying it for years and iv never got round to it . Do you think a reversal would take under a single cfl?
 
S

Seraphim19

250
93
Do any of yours ever produce more nanners than your average fem seed?or are they just as good sexual stability wise?

To ensure you don't produce hermie seeds it is best to stress test the plants to be reversed and the mother plant. if you test them and they don't hermie then you are highly unlikely to produce anything but healthy, stable female seeds
 
H

happy b

Guest
haven't seen a nanner yet.i've gifted at least 50 of these to a few guys.no reports of nanners but i did get a few runts and mutants.
Well that's to be expected I suppose . iv got a few gsc s1 in veg that wer made by a fellow farmer and gifted to me and they have some strange mutations in the leaves and stuff but theyr growing just fine . They looked kinda weird wen they germed as well .But theyr going fine so far.
 
S

Seraphim19

250
93
Iv gotta try this . iv got loads of strains I would love to reverse . But iv been saying it for years and iv never got round to it . Do you think a reversal would take under a single cfl?

The simple answer is YES!!!
I have reversed a plant under a single 11w cfl bulb in a kitchen cupboard so I know for a fact it can be done
 
north knect

north knect

1,203
163
Man this has got me thinking the possibilities!! This thread will change to much in some of our minds..ima still grow out the odd male but this will help to keep some nice keepers
 
Top Bottom