I Placed My Ebb And Flow Fittings Too Close Together For The Nut.

[bankcee]

Great, I was overly excited about finally putting my DIY ebb and flow table together. and I rushed through it and fucked up! So I drilled the holes place fill and drain fittings in their places and they fit fine.. then I tried screwing the washer and nut on and the nuts are overlapping. anyone have an idea what I can do?

 

[12345678989]

Patch one hole seems about it, or buy a new tray. Don't you only need one hole anyway. The table drains back through the pump once it shuts off right.. no drain hole needed. Just fill