Tired of trainwrecking other peoples threads? Well then, come party at the captains! Trainwreck this thread with…….trains? Anything goes here……….

  • Thread starter Captspaulding
  • Start date
  • Tagged users None
MartyMcFly42oh

MartyMcFly42oh

1,654
263
Here’s some of my most recent harvest, finally dry enough to smoke. Smells so nice too. Getting little citrus, sweet notes, almost like a sweet cream , underneath that is burnt rubber and gas!!!
IMG 4989
 
Captspaulding

Captspaulding

What’s the matter? Don’t like clowns? 🤡
Supporter
17,893
438
Here’s some of my most recent harvest, finally dry enough to smoke. Smells so nice too. Getting little citrus, sweet notes, almost like a sweet cream , underneath that is burnt rubber and gas!!!
View attachment 2127534
Beautiful work my friend.
Some proper frost right there.
👊🏻🤡
 
Putthataway

Putthataway

1,539
263
I am going to repost my question again. According to my light I should be switching on the red diodes
IMG 0748
We are at 25% on the main dial. That’s the lowest rating. I can’t go lower as that’s 0%. I raised the light to the maximum amount I a finger length between the filter.
IMG 0804
^ here’s what I mean by this. The red diodes are on a separate dial and according to the light manufacturer should already be on. What’s all your thoughts, especially @Captspaulding since you have been advising me to lighten up the light? I have done everything you asked I don’t want to fuck up things. If I need to take the up any further that exhaust and filter would need to come out.
IMG 0802
IMG 0803
Here they are I put the tallest on the right and short left. I would prefer it even on the light but I can get the right side a few mm more being the canister being in the way. My question can I turn on the red dial?
 
Leoman

Leoman

782
243
I am going to repost my question again. According to my light I should be switching on the red diodes View attachment 2127536We are at 25% on the main dial. That’s the lowest rating. I can’t go lower as that’s 0%. I raised the light to the maximum amount I a finger length between the filter.View attachment 2127538^ here’s what I mean by this. The red diodes are on a separate dial and according to the light manufacturer should already be on. What’s all your thoughts, especially @Captspaulding since you have been advising me to lighten up the light? I have done everything you asked I don’t want to fuck up things. If I need to take the up any further that exhaust and filter would need to come out.
View attachment 2127539View attachment 2127540Here they are I put the tallest on the right and short left. I would prefer it even on the light but I can get the right side a few mm more being the canister being in the way. My question can I turn on the red dial?

I put my inline fan and filter on the outside of the tent just in case extra room is needed to raise the light. Just have to rig it up where air is blowing out of the filter. Noticed no difference between inside and outside other than more room.
 
Putthataway

Putthataway

1,539
263
I put my inline fan and filter on the outside of the tent just in case extra room is needed to raise the light. Just have to rig it up where air is blowing out of the filter. Noticed no difference between inside and outside other than more room.
I haven’t needed it at 25% but couldn’t tell you on 25% red and 25% main dial. If I recall correctly I wasn’t able to make it work with my room. I won a bad ass light but I feel like I need to learn something before stepping into something twice as big and better. I can tell you that tent pumps a consistent temperature of 85 degrees with light at 75-100% which is its supposed target temperature after it is on winter or summer.
 
Captspaulding

Captspaulding

What’s the matter? Don’t like clowns? 🤡
Supporter
17,893
438
I haven’t needed it at 25% but couldn’t tell you on 25% red and 25% main dial. If I recall correctly I wasn’t able to make it work with my room. I won a bad ass light but I feel like I need to learn something before stepping into something twice as big and better. I can tell you that tent pumps a consistent temperature of 85 degrees with light at 75-100% which is its supposed target temperature after it is on winter or summer.
So, I say if you have that new badass light, use it.
Alls you need to do is start at a solid 36 inches from canopy. At no more than 10% output. Less for seedlings. Then slowly dial it in if needed, with the power out put and not height until you know what’s what.
 
Putthataway

Putthataway

1,539
263
So, I say if you have that new badass light, use it.
Alls you need to do is start at a solid 36 inches from canopy. At no more than 10% output. Less for seedlings. Then slowly dial it in if needed, with the power out put and not height until you know what’s what.
Lol. I am going to need another tent for that. Room options is canceled & straight up a bad idea with the location. You Texans have humidity. I don’t only hot and dry hvac removes moisture just like your car air conditioning. The problem here is that it is sucks out everything. I will need a tent.
 

Latest posts

Top Bottom