Im ditching my Rev Micro DEVA lights. they do not hold up in a room with high humidity and possible water vapor condensing on the fixture. the PCB will short out or get hard water residue on it and cause them not to work. just a result of having a PCB fully exposed to the grow room environment...
Bump on the triminator versus trim pal I'm selling my greenbroz unit as it turns all of my colas into Smalls. I've read that the triminator has a smaller diameter tube thus the tumbling action is more gentle on the Buds versus the trim pal that has a further drop for the buds to travel and crash...
I've got a greenbroz here and I'm not happy with it the stems get caught in the blades and the brush in combination turns your nugs into Smalls it cakes up way too fast and gets hash between the two blades and stops functioning properly I'm looking to switch to a triminator dry does anyone have...
has anyone gotten full spectrum extracts (winterized at -25f) to stabilize in PG? i have separation after about 3 weeks in a vape cart. is my winterization too warm to pull out all the waxes?
literature says 200-260v 260hz is what the LFSW CMH ballast outputs, this lamp is designed to work with this ballast.
My Rev Micro DEVA is 100hz 400v output probably wouldnt work with these CMH lamps
I cannot find the voltage and hz output of the Sunplix ballasts...
what ballast do you have?
I do dry trim. It takes me about 7-8 hours to trim 1 lb. Which right now equates to about 3lbs a week max I'm able to get through myself so in essence it's taking me more time to trim and finish before the next run is ready
if you look at rosin id look at crd.inc on IG they make cheap drip tech units, you could batch squish preloaded ingots and drip it straight onto a platter without cleaning between presses