agrohippie
- 31
- 18
Got my old cabinet set back up!
Gotta clean lower half and figure put air flow. Top has a 4 bulb 2' t5 with red and blue spectrum lights. Bottom has 4' 4bulb t5 with red and blue spectrum.
Im still woking kinks out of the flower tent mostly temp issues. I will be dropping down to 6 plants in flower in future. Possibly taking the bucket system out and using a tray system. Light in tent is a 630w cmh 2 bulb.
In regards to my cabinet, im not sure what to do. I'd like to do hydro to be able to go from this box into my flower tent. Top section section will be used strictly for cloning and propagation. I will run two domes, one for clones one for seedlings. When spring hits plants will also go from the box to the outdoors.
So my question for everyone is this,?
What should I do with the lower half of my box to go to either an ebb and flow table or into my buckets?
Gotta clean lower half and figure put air flow. Top has a 4 bulb 2' t5 with red and blue spectrum lights. Bottom has 4' 4bulb t5 with red and blue spectrum.
Im still woking kinks out of the flower tent mostly temp issues. I will be dropping down to 6 plants in flower in future. Possibly taking the bucket system out and using a tray system. Light in tent is a 630w cmh 2 bulb.
In regards to my cabinet, im not sure what to do. I'd like to do hydro to be able to go from this box into my flower tent. Top section section will be used strictly for cloning and propagation. I will run two domes, one for clones one for seedlings. When spring hits plants will also go from the box to the outdoors.
So my question for everyone is this,?
What should I do with the lower half of my box to go to either an ebb and flow table or into my buckets?