Posting up my current grow

[Peppersmints]

Your grow light seems wonderful and your growth looks good! congratuation

Thank you ! A fews weeks still remain on this one, I should start some new seed soon il update on what is available in my seed drawer for next grow :)

 

[Peppersmints]

Week 4 or day 29 since switch, cut the watering by half, topped nutrients. The Candy cream have some leafs burn, nothing too big... wondering if it’s the foliar spray or too much wind exposure... at this stage, too late to do anything. Other have no symptoms, will keep on going like that no further test required in my opinion

 

[Peppersmints]

Day 33

Good looking !

 

[Peppersmints]

Late photo from Sunday last week (37 days ) currently on day 44 , will update with new picture. I see lots of yellowing leaves, I’ve did up my dosage to 1300ppm~. I’m ending week 6, I have not yet looked at my thrichome, but it’s getting sticky in there. I’ve moved them around so overall light reaches and develop most of them equally? I don’t think I will pull one pound total, or if so, I’m lucky. I will probably put the net today and squitch them out a little. For next grow, I’ve started 6 seed. 2 auto ( lemon haze ) , 2 white widow fem , and 2 bubbakush fem. I will put the auto on same schedule as the others, hopefully, the auto don’t bud too soon , I may send them outside if so to not disrupt the nutrients schedule too much, that is if they all survive Happy grow , updating later on for new sexy flowers

 

[Peppersmints]

Day 44, read up for status update. I didn’t put the net but I used few clip to open them more and defoliated a bit to open the canopy. There is a few useless bud but at this point, they might just go into edible

 

[TheGreek_978]

Great grow!!!! I’m extremely impressed!!
Did you top any on these?

 

[Peppersmints]

Great grow!!!! I’m extremely impressed!!
Did you top any on these?

thanks, and at 4th branch upon main ive topped there, so there is suppose to be 8 arms around it or so on each, but except that, Ive removed about 50% of underneath to avoid popcorn buds, but i still have some! Alot of LST, using 3d printed clips and some garden wire, 8 week vegs bending around most possible to cover the whole 4x4 table. I am happy with the result, but there is still room for improvement....

I expect around 4.5-5.5 oz for cream cheese and Candy cream , and 3-4 for bubblegum ( tho, with comparing to my ancient grow, i may have mistaken the bubblegum and the candy cream from a long time ).

Next grow is suppose to have 3 different genetic ( White Widow, BubbaKush,, Lemon Haze Auto ) that is if everything goes alll rights :D

 

[Peppersmints]

Day 49 flower, still all I see is clear thrichome, yet somehow one ( Candy Cream ) seem to be showing sign too hot temperature out of 3, again, the first plant near the door seem always less healthy then the others, yet, it havent slow his production as its the biggest between the 3. Light are about 20-22inch but those big cob lights hit hard more toward the center. I will modify the inline fan from a 6 to a 8, cause right now its 24h/7 on and its getting too hot in there as the cold winter temp are over. I will try my thermal seek camera before to look at head temp , but the fan come with a temperature probe timer/controller..I will try and avoid starting the AC as it is not yet really the summer :D and upgrade the room by almost doubling the CFM as well a new carbon filter matching it!

 

[Peppersmints]

Here is how I am having fun, as much a developing my picture taking talents I had a nice deal before end of last grow, that camera (d5500 Nikon) had only 300~ photo taken, with the macro lens(micro 40mm 1:2.8) and the original that come with it for a little 500$ Plus all accessories bag etc, what do we do to make them look good huh ?

 

[Peppersmints]

I think the upgrade as well as flipping that 4 inch to a 6inch will help, as much as correcting the conduct straight. I used reducer 8´´ to 6 3D printed after putting a 2 coat of aluminum tape over . The model used was too flimsy to my taste but quickly printed! I will upgrade the intake by a 6inch. The negative pressure has increased a lot as I doubled the exhaust also some foam insulation around some place at the door. The fan is putting a lot of extra work even at 6/10 speed, and much quieter. I made a simple hole for the sensor and patched over aluminum paper for now. Hopefully, this will help with temp around head witch are around 78f at peaks if the sensor is right! Filter seem to be doing some good work too

 

[Peppersmints]

Update picture day 51, defoliation made. Ppm was quite high to my liking (1600ppm~) I flushed the water, cleaned reservoir and pots filled again with florakleen for 2hours circulating( ppm went from 300 to 600 from tap water ) then flushed again. Filled nutrients around 950ppm and back on normal schedule !

 

[Peppersmints]

Day 54 :) feel like less yellowing since flush

 

[Peppersmints]

Day 55, little defoliation, dropped nutrient solution around 750ppm and 5.8ph. I will be verifying thrichome again soon, as well a dropping light time to provoque their maturity. I will flush water to tap for at least 2-3 day before harvest but I would prefer a whole week. I know this is highly debatable, but if there is no benefit or so, I see one where I save some nutrients feedings

 

[Peppersmints]

Day 60 since flip, Light at 11/13 , water kept around 750ppm, I dont feel the need to add more nutrient till the end now. New fan system * humidity and temp control * work wonder. D 74*F and N 60*F and Humidity around 58 at night and 40 day. The girlfriend also happy as no more small odors on random occassion. She hate the smelll I am hopefulll to see some ambers thrichome by this weekend on the buds, somes small leaves have alot already. Here a few more pictures :D

 

[DankNugz420]

Nice man, the finish line is in sight!

 

[Peppersmints]

Picture taken on Day 64, dropped 10hours, will cut off light on day 67 ( currently day 65 ). They scream pick me !

 

[Peppersmints]

I decided to harvest after 36hours of darkness. I am supprised by the overall, a fews bud i removed for edible or bubble later on, and might add a little more small buds in there but i have about 2800g of wet bud. Drying and curing on the way ! There is also a few baby on the way for next, will update soon. I believe i will be around 0.6g/watt. Need to do better :D

 

[Peppersmints]

Been off here a little. Here update on the 6 on the way. Biggest is the auto( lemon) in soil. I feed fro’ reservoir. I transplanted them as baby in bad shape. They been left with dry air a little too long on the roots but they are working it back up. The auto show quite a few anomalities on his growth but it is showing maturity already. I will be able to switch different nutes since it’s not connected with the others on the feeding! Smallest other in a pot in the back might be my future mother, I’m not decided yet!

 

[Peppersmints]

Here little update. Defoliation, LST and some HST. Watering been down to 5min every 6hours. I notice that 5gallon of clay pebble stay wet for a long time, they all finally get going from what seem to be overwatering.

 

[TheGreek_978]

Here little update. Defoliation, LST and some HST. Watering been down to 5min every 6hours. I notice that 5gallon of clay pebble stay wet for a long time, they all finally get going from what seem to be overwatering.

Where did you get those things for the branches? I’ve never seen them before . Seems to make LSt easier