Log In Register

THCosmic's Closet: Chasing the Cosmic High

Hey everyone! Starting a new grow diary for the new closet setup I have planned. Hopefully this becomes my final and permanent setup. Still waiting on my current grow to finish. I hope to have them all harvested before November. Setup: 5'x5'x8' Closet 5x...
Home Forums Medical Cannabis Cultivation Grow Diaries THCosmic's Closet: Chasing the Cosmic High
Grow diary eligible · Medical Cannabis Cultivation

THCosmic's Closet: Chasing the Cosmic High

by THCosmic · Started
1d
Running
0
Updates
75
Replies
3
Images
Discussion below · 75 replies
Page 1 of 4 · Replies 1–20 of 76
THCosmic

THCosmic

Posts
693
Reactions
1,182
Joined
Jul 22, 2025
Points
143
Hey everyone!

Starting a new grow diary for the new closet setup I have planned. Hopefully this becomes my final and permanent setup. Still waiting on my current grow to finish. I hope to have them all harvested before November.

Setup:
5'x5'x8' Closet
5x 11-gallon Mobile RDWC 2-Bucket Systems
3x 135W Full Spectrum LED lights
2x 120W Full Spectrum LED lights
950gph Air Pump
Govee Sensors
2x Oscillating Fans

Mobile RDWC:
2x 7-gallon Buckets
6" Net Pot Lid
210gph water pump
2x Air Stones
On Wheels (coming soon)
DIY Trellis Net (coming soon)



I will have more images after the current harvest. I will do before and after picture of the closet as well as a full assembly guide for the DIY mobile RDWC units I will be using.

I plan to start out by germinating 5x Blackberry Kush Regular seeds from Eighth Brother. I will grow them under a 6/2 light schedule for 4 weeks them switch to 11/13 until sexed. Remove all except 2 females, maybe keep 1 male for pollen, moved to a tent of course. I'm banking on 2 of the 5 being female. Odds should be in my favor.

Thcosmics closet chasing the cosmic high


I will have started to germinate more seeds before flipping the regs to 11/13. I will then run these 12/12 (or maybe 11/13) from seed. I will choose seeds known for shorter flowering periods so that they will hopefully end around the same time as the regs started before them.

Thcosmics closet chasing the cosmic high 2

These are the seeds I have to work with. I am already growing a Tutankhamon (AK-47), so I will probably not grow that one this round. All of these seeds are a decade old so I will be germinating at least 2 of each of the 3 strains I choose.

Now to wait until my current grow finishes before I can start work on the closet. See you all in a month!
 
Hey everyone!

Starting a new grow diary for the new closet setup I have planned. Hopefully this becomes my final and permanent setup. Still waiting on my current grow to finish. I hope to have them all harvested before November.

Setup:
5'x5'x8' Closet
5x 11-gallon Mobile RDWC 2-Bucket Systems
3x 135W Full Spectrum LED lights
2x 120W Full Spectrum LED lights
950gph Air Pump
Govee Sensors
2x Oscillating Fans

Mobile RDWC:
2x 7-gallon Buckets
6" Net Pot Lid
210gph water pump
2x Air Stones
On Wheels (coming soon)
DIY Trellis Net (coming soon)

View attachment 2530973

I will have more images after the current harvest. I will do before and after picture of the closet as well as a full assembly guide for the DIY mobile RDWC units I will be using.

I plan to start out by germinating 5x Blackberry Kush Regular seeds from Eighth Brother. I will grow them under a 6/2 light schedule for 4 weeks them switch to 11/13 until sexed. Remove all except 2 females, maybe keep 1 male for pollen, moved to a tent of course. I'm banking on 2 of the 5 being female. Odds should be in my favor.

View attachment 2530974

I will have started to germinate more seeds before flipping the regs to 11/13. I will then run these 12/12 (or maybe 11/13) from seed. I will choose seeds known for shorter flowering periods so that they will hopefully end around the same time as the regs started before them.

View attachment 2530980
These are the seeds I have to work with. I am already growing a Tutankhamon (AK-47), so I will probably not grow that one this round. All of these seeds are a decade old so I will be germinating at least 2 of each of the 3 strains I choose.

Now to wait until my current grow finishes before I can start work on the closet. See you all in a month!
Good luck (:
 
Over the next week or so I will be putting together the remaining 4 RDWC units. I will document each step in case anyone wants to build something similar. I mentioned in my other grow diary that there was a small leak in the first one assembled. Turns out I didn't use enough plumber's tape. I will be going extra heavy with the plumber's tape from now on. All threads will get a ton. I bought plenty of plumber's tape, so might as well use it. Better safe than sorry.
 
Made a table of flowering times to figure out which 3 strains I will grow alongside the Blackberry Kush. The columns numbered 7 through 12 are the number of weeks the plant flowered in someone's grow diary. These numbers are more realistic values than the estimated weeks provided by the seed bank.

Seed BankStrainWeeks789101112
Pyramid SeedsGalaxy7-8231000
HeavyweightFruit Punch8012300
Barney's FarmPeppermint Kush7-8120100
Garden of GreenSuper Critical Bud CBD7-8242030
SeedsmanAlaskan Purple9-11088211
SeedsmanWhite Widow8-100712560
There were a ton more Alaskan Purple and White Widow grow diaries, but I just stopped counting after so many. Obviously they will not take 7 weeks to flower.

Looks like I will be going with the following 3 strains:
Galaxy by Pyramid Seeds
Peppermint Kush by Barney's Farm
Super Critical Bud CBD by Garden of Green
 
Marking all buckets to drill holes. These 2 holes are on every bucket.

PXL 20250924 190505826

Tools and parts

PXL 20250924 1910544432
PXL 20250924 1911232562
PXL 20250924 1911334642

Find the center using the marks on the bucket.

PXL 20250924 191430770

Line up marks to keep measuring tape straight.

PXL 20250924 192316335

1-1/8" for the center of the 1" hole. I wrongly marked 1-1/4" at first.

PXL 20250924 191755677

I just eyeballed this mark for the 5/8" hole for the 1/2" water hose.
 
Used a 3/16" bit for the starter holes. Makes it much easier for the larger bits.

PXL 20250924 1936510462
PXL 20250924 193829432
PXL 20250924 193822290
 
1" hole saw for the bottom hole.

PXL 20250924 1942558532
PXL 20250924 194445279


Clean it up with a 1" bit and razor blade. Could also use sandpaper.

PXL 20250924 194605934
PXL 20250924 194658568
PXL 20250924 195143943
PXL 20250924 195350179
 
5/8" bit for the upper hole. This one doesn't really need cleanup afterwards since it does not need to be waterproofed.

PXL 20250924 195748673
PXL 20250924 195756535


Every bucket will get these 2 holes. Two buckets are connected together at these points.
 
Ye do a quick tap with high gran sandpaper if its pretty sharp. Better safe than sorry :p
 
Found some sand paper and sanded the edges of the bottom hole. I also had to make it a tiny bit bigger using the 1" bit.

PXL 20250924 201637655

Bulkhead and sandpaper.

PXL 20250924 201925092

Put the plumber's tape on extra heavy.

PXL 20250924 202133719
PXL 20250924 202732644
PXL 20250924 202811204
PXL 20250924 203015079

Put the bulkhead in the bucket. Even added some more plumber's tape afterwards.

PXL 20250924 203340084

Tightened the bulkhead nut until the rubber washers started to bulge out a bit. Too tight and the rubber washers become useless.

PXL 20250924 203833484

Added the male half of the union fitting. Only hand tightened so far. Need to find my other adjustable wrenches. This damn pipe wrench is too big, but is still needed to connect each half of the union fitting later.

Edit: On my first test build, it leaked from the male side of the union fitting. It leaked out from the threads, so obviously it just needed a ton more plumber's tape which I made sure it had from the start this time.
 
Adding the water level tubing.

PXL 20250925 184535268
PXL 20250925 184327373
PXL 20250925 184938473

Using the 3/4" hole saw made a hole with center 1" above bottom of bucket on opposite side of the bulkhead with male union fitting.

PXL 20250925 185542666
PXL 20250925 185611752
PXL 20250925 185641598
PXL 20250925 185711317
PXL 20250925 190224371

The elbow bulkheads I have needed to be swivel for my previous build. Non swivel ones will be easier to install. I had to rig these with rubber grommets cut in half so the 1/2" tubing fits tight.

PXL 20250925 191428631
PXL 20250925 191627788
PXL 20250925 191734731
PXL 20250925 191933534
PXL 20250925 192001502

Insert the elbow bulkheads into the hole with rubber washers and tighten.

PXL 20250925 192853411
PXL 20250925 193201925

In order to use tubing I already had, I went from 1/2" tubing to this clear tubing (not sure exact size). I then zip tied it to the bucket by drilling a small hole as seen above.

I put the water level tube on the bucket with the male fitting since that will be my reservoir while the female fitting gets the female plant. 😁

I read that flow direction from female to male can handle the most pressure so I went with that. Just coincidence the female fitting gets the plant.
 
Air hose hole is added to the female bucket with 3/16" bit. At the same spot as the water hose, but on the opposite side. You can put this anywhere as long as it is above max water level.

PXL 20250925 184130464
PXL 20250925 200148127
PXL 20250925 200157686

2 air stones, some tubing, and some fittings.
 
Hey everyone!

Starting a new grow diary for the new closet setup I have planned. Hopefully this becomes my final and permanent setup. Still waiting on my current grow to finish. I hope to have them all harvested before November.

Setup:
5'x5'x8' Closet
5x 11-gallon Mobile RDWC 2-Bucket Systems
3x 135W Full Spectrum LED lights
2x 120W Full Spectrum LED lights
950gph Air Pump
Govee Sensors
2x Oscillating Fans

Mobile RDWC:
2x 7-gallon Buckets
6" Net Pot Lid
210gph water pump
2x Air Stones
On Wheels (coming soon)
DIY Trellis Net (coming soon)

View attachment 2530973

I will have more images after the current harvest. I will do before and after picture of the closet as well as a full assembly guide for the DIY mobile RDWC units I will be using.

I plan to start out by germinating 5x Blackberry Kush Regular seeds from Eighth Brother. I will grow them under a 6/2 light schedule for 4 weeks them switch to 11/13 until sexed. Remove all except 2 females, maybe keep 1 male for pollen, moved to a tent of course. I'm banking on 2 of the 5 being female. Odds should be in my favor.

View attachment 2530974

I will have started to germinate more seeds before flipping the regs to 11/13. I will then run these 12/12 (or maybe 11/13) from seed. I will choose seeds known for shorter flowering periods so that they will hopefully end around the same time as the regs started before them.

View attachment 2530980
These are the seeds I have to work with. I am already growing a Tutankhamon (AK-47), so I will probably not grow that one this round. All of these seeds are a decade old so I will be germinating at least 2 of each of the 3 strains I choose.

Now to wait until my current grow finishes before I can start work on the closet. See you all in a month!
Hell yeah brotha! I not sure if i missed your last one completely or just fell off because i suck like that! But followed your link to here : ) BADASS! Dude! Very cool setup! ✌️
 
Just soaked some clay pebbles in hot water to remove most of the debris. Going to let it dry, sort into 3 sizes, and rebag the different sizes. When setting up the next grow I will soak and rinse again only what I need.

PXL 20251015 171007635
 
Sorted the pebbles through a screen (or cookie cooling rack 😆) to separate out the larger ones. Will also sort the small ones using the net pot and throw away anything that falls through.

PXL 20251015 211500239
 
My closet is finally empty so the tear down has begun.

PXL 20251103 164820846

Before removing everything.

PXL 20251104 200536261

Shelves removed.

PXL 20251104 235708599

Carpet removed!

That is enough for today. I need to flip the door before I do any more. I will do that tomorrow, as well as tarp the floor and mylar the walls/door.
 
Page 1 of 4 · Replies 1–20 of 76
Back
Top Bottom