Search results for query: *

Thanks for the heads up. I normally wear sandals but sometimes I have cotton socks with shoes. Would my shoes cause an issue? My boyfriend does wear polyester shorts sometimes... But we are technically outdoors when we do this so there's always rubber soles on our feet.

I also want to put it out there. The mushy looking part is hard. It crumbles if I snap it.

@fatawa I truly believe it's the moisture filter in my pump. I have done many runs and haven't changed it. Jolly rancher had a spot on it that I just broke off. I did the shark after and it was really bad... And then m39 that has spots in it. I did m39 last week and I actually cranked the temp...

@gumby420 what do you put your temps at? Ive read so much about temps that nothing makes sense anymore. There's people that go to 120 and swear by it and then people say never go over 110... There's so much misinformation out there.

K. I have a stainless steel closed loop extractor. Terpinator mk 4c. Butane comes out my tank and goes up the 5 lbs tube, comes down the cord into the chamber that sits in hot water, gets pumped out, goes through a coil that sits in ice water and back into the butane tank. I do this 3 times and...

I have a shed that is sparkles everything. I make sure to be extra safe. I'm not a fan of exploding. @tinderthumbs my return pump has a moisture filter. It's basically silagel.. that pack you see in jerky that you shouldnt eat. I have yet to change it. I just realized that I took apart all my...

I just looked at the m39 and it has the same spots. I ran the m39 a week ago and this didn't happen. I actually had the m39 at a higher temp in the vac oven last time so I'm going to eliminate heat on this problem. I'm going to check the moisture filter on my pump the pulls the butane out. And...

The temperatures in the vacuum oven I used was 96 and then when I put the m39 in with it I raised it to 105 because the m39 is rock hard and bubbles don't like coming out of it easily. Do you think my extraction temperature could have been to high? I found the butane cooled the water a lot so I...

The color is actually nice on the small spot that isn't a mess. Most of it looks like this and everywhere else is cloudy. I'm not worried about the color. I'm worried about why this happened so it won't happen again.

Going to dagobah

No I didn't. I was trying to figure out what went wrong and I saw something about freezing. I wanted to look more into that.

I haven't been making shatter for very long. I know when humidity hits the shatter it's all down hill. My room has very low humidity so I don't know how this could have happened. I have done 3 types in the past few days. One with Jolly rancher that came out great. Great white shark... And m39...