Search results for query: *

I finally got the time/opportunity to do another small pressurized column run yesterday. I encountered a moisture problem I was hoping to find a remedy for. It rained the previous day before the run, and the day of my run the ambient temp was 75F and the humidity was high likely 92%. we usually...

Thanks for the link, that is a very good read! terpyhooves explained a lot in those posts.

Your post sounds like you have first hand experience, so I am listening. However your statement "Concentrates suck" I do not understand. If you are referring to creating e-liquid using PEG400 I tend to agree the taste is not very appealing, hence the reason I am considering adding terps. The e...

Thanks for the expanded information. I am a bit surprised to hear winterizing INCREASES potency, do you care to explain further? Also besides terps, what type of non-target molecules does winterizing remove? Thanks

I have used the PEG 400 and it seems to work fine. However I am going to try terpenes because I am all about taste, and the PEG400 is bad for you if it is overheated, as was mentioned in another thread recently. Thanks for the links to the vids,

I agree. I am new to ALL of this stuff but it seems to me vaping is the way to go. I have not wanted to do any flower since I discovered BHO/concentrates, and vaping is the next logical step IMO. I have added some pineapple flavored PG to shatter, put it into an oil cart and I smoked it. Is...

Thanks! I appreciate very much you sharing this info with me. My last run still rips well despite being purged to hell and back! Lol I actually purged/heated about 1/2 of the run to almost wax (a first) and the other half at a lower temp is flexy shatter. I have no clue what good shatter...

My setup is small and simple. I have a stainless vessel about a gallon size. A top that has ball valves and a gauge, I also use a CPS CV200 digital vacrometer. The setup rests in a electric skillet in a sand bath. I measure temp of the sand bath with an IR thermometer, and when I take the lid...

I am so frustrated at this point! I just cannot figure out this purge thing no matter how I try it. If I keep the temp around 120F and appropriate vacuum, it eventually stalls and stops bubbling like it is too thick to purge. I also tested a small amount at 135F and vac. I think I ended up with...

:cool: Thanks! I must mention that I have never had any BHO except for the stuff I assembled.

Ok sounds like I am on the right road thanks! I just cant see very far ahead.Lol What is meant by "loose its stability"? I see that everywhere, but I am not understanding its meaning. I have created some glass like shatter and some pull and snap type, and some stringy sap like resin. They were...

Greetings all! New to the BHO scene, kinda surprised I missed the boat by a decade. Lol. Anyway, I did a lot of reading here and there, and have two personal sized runs under my belt that were successful IMO. I am interested to see if there is a current (2018) prescribed method to follow for...