200amp Sub-panel Recommendations

chrometrichs · Feb 14, 2012

Hey Farmers and electrical gurus, what should someone look for in a quality 200 amp 3 pole subpanel? Thanks!

hiboy · Feb 14, 2012

chrometrichs said:
Hey Farmers and electrical gurus, what should someone look for in a quality 200 amp 3 pole subpanel? Thanks!

200 amp load center, you must be in an industrial area. Murrays work great, squard D is fine too. Either of these will do u well. Very popular.
A main breaker in your load center is ideal also. 42 space would probably fill ur needs
hb

Olyver · Feb 14, 2012

Siemens and C-H are the better choice when it comes to 3-phase panels IMHO. As Hiboy said, make sure it has a main breaker.

hiboy · Feb 14, 2012

Olyver said:
Siemens and C-H are the better choice when it comes to 3-phase panels IMHO. As Hiboy said, make sure it has a main breaker.

Forgot about siemens, yes top notch for sure. Probably the best out there. Only supplyhouses or online will carry them, dont look for them at your local home depot or lowes.
h

chrometrichs · Feb 14, 2012

Thanks guys, the MLC is a siemens, so I'll probably go with one of those. Would you recommend any heat or override sensors, where's a good place to look into accessories like that?

Olyver · Feb 15, 2012

chrometrichs said:
Thanks guys, the MLC is a siemens, so I'll probably go with one of those. Would you recommend any heat or override sensors, where's a good place to look into accessories like that?

You can hard wire a 200A 3-pole contactor, but that's going to be about $500 to a $1000. If you mount a NEMA enclosure 18"x18"x8" beside the loadcenter, then run some EMT or couplers, mount smaller contactors for each of the 240V or 120V loads you want to control. A Ranco or Johnson Controls makes a good high temp shutoff. Add a PLC and add some sensors to control various settings.

If you're comfortable with electrical work, you can do most, if not all of the work.

Olyver · Feb 15, 2012

Here is what a 200A 3-phase loadcenter would look like. It was built for 48 x 600W ballasts.

hiboy · Feb 15, 2012

Olyver said:
Here is what a 200A 3-phase loadcenter would look like. It was built for 48 x 600W ballasts.

Thats one sic pic..
hb

200amp Sub-panel Recommendations

200amp Sub-panel Recommendations

chrometrichs

hiboy

Olyver

hiboy

chrometrichs

Olyver

Olyver

Attachments

hiboy

Privacy & Transparency

Privacy & Transparency