Gavin 48 said:

I do not, and I did jump the gun on vacuuming it probably. I'm new at this and could use all of the advice I can get.

Click to expand...

Graywolf said:

If you slowly raise the heat with the lid on, but no vacuum, until it fully melts, it should be no higher than 120F and more likely 110 to 115F. If it reads 150F with your infrared, you are either shooting through the puddle and measuring the hot surface under it, or your infrared gun is out of calibration, or...........??

Do you have a calibrated immersion thermocouple to compare the reading to?

Click to expand...