sixstring
- Posts
- 7,079
- Reactions
- 29,605
- Joined
- Jul 26, 2011
- Points
- 313
did you wire in series ?
I have it unwired now. I basically split off the out put to each lamp. So it's essentially two lamps running from the same driver.got any pics ?
I tried wiring straight from the driver to one light also and the same thing still blinked on and off.got any pics ?
Haha it wouldn't surprise me! The wiring was done right I think just parallel maybe? I checked it with a circuit tester but it wasn't running the light right?Be careful or your gunna blow some shit up of shock the hell out of yourself lol
Am I able to just wire the fan right into the power to the chip or will that effect the chip itself? Do the fans need seperate power?yeah thats not the driver for parallel wiring.
I got you no worries man!you know you have to post pics of the light all lite up now or im not going to believe you got it fix right ?
:jimlad:
omg,no!! those fans need a smaller power supplyAm I able to just wire the fan right into the power to the chip or will that effect the chip itself? Do the fans need seperate power?
Well damn.. Any recommendations for two Arctic 11 heatsinks?omg,no!! those fans need a smaller power supply
.25a, +12v dcyou can run the lights for a few minutes to check it out without the fans,those heatsinks will be fine for 5 or 10 minutes by themselves.but you need something small,some guys use old cell phone chargers to power a fan or 2.whats the specs on the back of the fan ?
Yes it's that same one. Also pic of lights on!.25a, +12v dc
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?