Egzoset
- 122
- 28
Is this a project being built from scratch?
Perhaps look into modification of existing high power RF amplifiers to your purpose?
Wait... Is this what you are trying to accomplish?
If the circuit you are trying to build is just the low voltage side if a high voltage power supply, have you looked at Tesla coil designs?
...what is the frequency range and power required?
...look at a simple push-pull... ... ...newer designs use FETs.
The exciter can be a signal generator for precise frequency control.
If I'm on the roof messing with antennas, I probably do have spare parts for a butane-operated soldering iron, and a few other things, in my pockets!
...with time, the lungs tend to protest.
If I get this right, you are trying to accomplish thermal vaporization via rapid induction?
In the end, isn't it still just heating up the chamber just very quickly?
It's 2095...
Perhaps consider a higher portion of the RF spectrum.
Direct material vaporization in a resonate microwave chamber?
X-Rays? Gamma Rays?
Now that looks like a nice, basic RF amp!
...You can get away with 100 watts at 12VDC if the frequency is lower...
...your design must account for input power at J1, gain and frequency of Q1/Q2 and output impedance.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?