Log In Register
  • Thread starter Thread starter Guiltydwight
  • Start date Start date
  • Tagged users Tagged users None

Leaves started yellowing about 4 days ago need a bit of advice

Guiltydwight 14 Replies 2,017 Views
Page 1 of 1 · Replies 1–15 of 15
1
Guiltydwight

Guiltydwight

Posts
159
Reactions
164
Joined
Apr 11, 2021
Points
43
Skittlez autoflower in promix hp ,led light 24 " away ,temps 23 -25 c and rh 50-55 , watering every 3 to 4 days and growtek nutes every second watering and the plant is 60 days old from seed thanks
 
20220605 190703
20220605 190656
20220605 190648
 
Im growing zkittlez autos also. Also in promix following same feed schedule as you and im noticing also leaves starting to yellow. Maybe just there life cycle.
Thumbnail IMG 0295
 
Flush and feed… 3x the pot volume of water and a light feed 1x pot volume after then let dry well.

After the feed till pot on a 45 angle for a few minutes to get some extra run off.

At this point you wont see any improvements before harvest bit it should correct any nutrient issues.

For this you do want to ph and temp adjust the water since you will be running so much through
 
Probably cut N to much to early but its very common to see nutrient issues later in a grow. So the flush will kinda reset the media and prevent it form getting any worse.

Just make sure you tilt the pot after ti get the extra runoff
 
Flush and feed… 3x the pot volume of water and a light feed 1x pot volume after then let dry well.

After the feed till pot on a 45 angle for a few minutes to get some extra run off.

At this point you wont see any improvements before harvest bit it should correct any nutrient issues.

For this you do want to ph and temp adjust the water since you will be running so much through
I flushed yesterday with the same amount of water but didn't feed anything should I trow some feed in there tonight?
 
I flushed yesterday with the same amount of water but didn't feed anything should I trow some feed in there tonight?
Yes and tilt the pot after… to often you see a flush to reset media and clear buildup then not followed by a feed and you see deficiencies shortly after
 
Page 1 of 1 · Replies 1–15 of 15
1
Back
Top Bottom