Allright changed up a bit, got my 2nd light installed, changed my air intake a bit, it’s a MacGyver intake 100% used a 6” fan, some 4” drier vent, and a cookie dough container
some gorilla tape and boom new intake haha. Pulling air from lower to the ground on the concrete floor that’s cooler to help control the heat with the 2nd light, staying steady at 79f at 60% fan speed on the carbon filter about 36-45% RH with lights on, added 2 bug bowls of water between the plants for evaporation. lower intake will shut off with lights on the timer only allowing upper fan to pull some air with lights off, sticky traps will arrive tomorrow just to stay ahead of the game
Feels nice to let them spread out a bit and feel fine about light coverage, not sure about training on the autos, would like to scrog but looking for input, area is about 60”x38” I don’t want to top them as I’ve seen good and bad for tipping autos I’d rather train, what week would be good to start training them, the gorilla glue is a week behind but I think that’s close enough and I can deal with a running a bit later in a single plant if just move it to the back center before installing the net
Any other input please let me know!
Also looking for input on best location for fan controller probe currently zip tied to handle of top center planter so it’s near plant level but not sure if that’s the best location, I assumed it was because that’s what the plants actual growing environment is
Running RO water now, PH 6.2 no ferts or neuts yet as I’m running 100% FF
happy frog I figure I have another week minimum before I start introducing ferts (going to
fox farm lineup of ferts /neuts as they are available locally)
Lights as stated before, now 2x 1500w KingLED lights went full bite and am running both veg and bloom switches on, leaves are reaching up for the lights and looking happy. Used some zip ties to pick them up higher than the hangers allowed currently about 28” from tallest plant