Thetinman
- 268
- 28
Ya that’s what I run currently. 2 burner from titan. I use it in a 10x10 lung room and use my cloud line to pul it into both my 5x5 flower tent and my 2x4 mother tent. You’re plugging one side? What size area are you enriching and what are the problems you’re having?Oh it's a Titan Controls burner brand new.
Just a programmable timer will work. Can set time and duration. Calculate the room in cf and then take the fan cfm and divide the room cf by the fan cfm and thats how many minutes you need to run the fan to change the air in the room provided you have good mixing. I would say if you double the duration you can consider it sure to do so.Ya that’s what I run currently. 2 burner from titan. I use it in a 10x10 lung room and use my cloud line to pul it into both my 5x5 flower tent and my 2x4 mother tent. You’re plugging one side? What size area are you enriching and what are the problems you’re having?
I was going to say the same. I have half my shit smart switched. I found some sweet 15A smart switches after I burnt out a few running a 1000w hps and a few hundred watts of leds on the same line lolJust a programmable timer will work. Can set time and duration. Calculate the room in cf and then take the fan cfm and divide the room cf by the fan cfm and thats how many minutes you need to run the fan to change the air in the room provided you have good mixing. I would say if you double the duration you can consider it sure to do so.
I run a sealed room never vented with bottled... however I would not do the same with a burner... that has to be periodically vented your call though. Just a warning.You guys crazy. Just spend the dough (DOH!) and even it out. Gives an assurance, that your obviously constantly leaking. Not good either withing home environment, seriously.
Seal up better with shoe goo, did my whole room with staples and shoe goo!
Higher temps and lower humidity are beneficial with co2 and I would border on saying necessary
I have an autopilot controller and in a 10x7 I go almost 2 grows on a 20lb tank.To Hughe? Awsome saying!
Naw, I am just using a ppm controller. Set and forget. Bottled air or propane? I ask because you may want to put these items on your list, after say a harvest.
What happens apparently, if even out, cuts off at night, then if you use cold co2 from bottle, you can get the "fuzzy logic". Cannot use for burners.
Does "fuzzy logic" work? Good question, cant use it. Must pipe with spaghetti tubing on ceiling to drizzle only downward. Only cold bottled will work.
I bought the Auto Pilot. Check it out online. It only turn on when its needed. Will not exceed 3000 ppm. So that's the magic number there. Much higher could be dangerous.
People say you should use this or that, that why I am writing this thread.
Danger is ever present, too leaky, seal the room. But a good seal will be risky to just using a timer.
So get ya an Autopilot PPM controller. Keeps things even and who knows, you will probably save some money on tank refills.
T
5-10% lower than VPD.This is the first I've heard that lower humidity is beneficial when burning co2. What humidity do you try and maintain during the different phases of your grow. How does this tie into those following VPD? I suppose following VPD perameters but keeping humidity in range but on the low end of that range is what I should be aiming for?
Well, first what is that? VPD, I will have to look that up. A calculation? Uptake or discharge from plant?
Do NOT use charts they are bullshit and likely to cause you issues..Ok, checked out chart, I am in the middle green area. Very interesting an I will use for future, thank you.
T
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?