and ai did the drawing.i remember when it couldnt write for shit and now...That's a great chart for reference!!
Going to post that EVERY time a new grower asks ANY nutrient question!!!
soo the bottom plate is "secured" with 2 rods that are connected only to the top but i cant find any screws soo maybe its welded and they move like crazy and since i pressed it wrong they allsoo now have notches that the plate gets stuck to. i allsoo noticed the bottom plate runs away from the press probably because of the same reason. i think they need to be replaced and it would fix all my problems.but i dont know anybody that does that....The press work ( plates )are not centered.
This uneven pull places stress in the direction the screws are NOT made to have. Any torsion load ( uneven unlevel uncentered can cause that to fail in a very spectacular way.
I have zero experience pressing oil but I have 40 plus years pressing bearings, bushings and axles and that is an unsafe setup on your press.
Please be careful.
Center the load.
If it still pulls left or right find out why.
Setup you press for just enough open space to put you weed in there the more compact the forcing screw the straighter your press. You do not want to jack it 8 inches to contact.
Edit**
I would disassemble that press and check the long spring and rods. The right side looks bent onwards but it can be the angle.
You can also use a plumb bob ( that should be hanging on your press for checking ) to look at it.
A line or string and a 1/2 inch nut, a big washer, something with weight to hold at the top of that right side rod assembly and see if the bottom of the string is still in the middle.
Haze comes and goes : ) he’ll be aroundHey man. Where you at.
Havn't seen you in a while
What's in the center of the spokes? Is that water?After a single night most opened.cannabis seeds are over 5 years old soo maybe they will need a few days but i would say the chamber is working
allsoo tried the 1% h202 doesnt look like it did harm soo i think i will keep using it
i don't know for what that is its hard to grab it but you can use it to lift all of it together. water goes under the mesh its lifted off a little bit then on the mesh goes paper like a wickWhat's in the center of the spokes? Is that water?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?