KushMan707
- Posts
- 131
- Reactions
- 231
- Joined
- Nov 18, 2014
- Points
- 43
Hey whats up everybody,
I haven't grown indoor for a few years now and am getting back into it. I am using a 4x8 hydro hut with 32 Gorilla Glue #4 clones on a 3x6 table. I'm using 2k of lighting with radiant hoods and quantum ballasts. For my growing medium I'm using botanicare readygrow aeration mix coco in #8 coco tek pots (they're a little smaller than 2 gl). I water using drain to waste. I use Advanced nutrients for the most part but there are a few things I switch out.
sensi grow+sensi bloom
bud candy
nirvana
rhino skin
bud factor x
kushie kush
overdrive
roots excelerator
hygrozyme
botanicare cal mag
I filter my water with a tall boy filter and upgraded carbon filter.
I just transplanted my GG#4 clones the other day. I ran a nutrient mix through my pots to thoroughly saturate and have a bit of run off. I am somewhat concerned because I tested the runoff today and it's 200 ppm higher than the solution I ran through it. Should I have flushed the coco better before I transplanted? Could this cause any immediate or long term problems? Other than that everything seems great since the transplant. I've run my sulphur burner once already as well to prevent powder mold. I cant wait to see what this strain can do! I know they are going to stretch a lot so I plan on using 3 or 4 ft stakes to manage the lengthy branches. Theres not much going on right now but I'll share some pics of the grow. I'm looking forward to sharing this grow with the farmers here!
Transplant/Week 1 veg: res apx. 80 gl, base ppm: 40
cal mag 100 ppm
roots excelurator 90ml
hygrozyme 500ml
nirvana 150ml
rhino skin 30ml
bud candy 150ml
sensi grow a+b 600ml
total ppm 720
I haven't grown indoor for a few years now and am getting back into it. I am using a 4x8 hydro hut with 32 Gorilla Glue #4 clones on a 3x6 table. I'm using 2k of lighting with radiant hoods and quantum ballasts. For my growing medium I'm using botanicare readygrow aeration mix coco in #8 coco tek pots (they're a little smaller than 2 gl). I water using drain to waste. I use Advanced nutrients for the most part but there are a few things I switch out.
sensi grow+sensi bloom
bud candy
nirvana
rhino skin
bud factor x
kushie kush
overdrive
roots excelerator
hygrozyme
botanicare cal mag
I filter my water with a tall boy filter and upgraded carbon filter.
I just transplanted my GG#4 clones the other day. I ran a nutrient mix through my pots to thoroughly saturate and have a bit of run off. I am somewhat concerned because I tested the runoff today and it's 200 ppm higher than the solution I ran through it. Should I have flushed the coco better before I transplanted? Could this cause any immediate or long term problems? Other than that everything seems great since the transplant. I've run my sulphur burner once already as well to prevent powder mold. I cant wait to see what this strain can do! I know they are going to stretch a lot so I plan on using 3 or 4 ft stakes to manage the lengthy branches. Theres not much going on right now but I'll share some pics of the grow. I'm looking forward to sharing this grow with the farmers here!
Transplant/Week 1 veg: res apx. 80 gl, base ppm: 40
cal mag 100 ppm
roots excelurator 90ml
hygrozyme 500ml
nirvana 150ml
rhino skin 30ml
bud candy 150ml
sensi grow a+b 600ml
total ppm 720
