M
Mmj120789
- 13
- 3
OK I'm in the process of setting up my purging chamber I've done stupid amounts of research and am looking for advice
Just fyi to get an idea So far I have
Ss baster for tube
1/2" thick 12" x 12" palsun Polycarbonate sheet for vac chamber lid.
IR thermometer gun
*Looking for 400 mesh (50 mic.) Screen 3" x 3" to prevent blow out
PTFE film to blast into & unbleached coffee filters
Hose clamp,
2" oil filled vacuum pressure gauge
1/4" male 50 micron air filter for back filling air in from atmosphere.
1/4" brass 4 way, Teflon tape
1/4" brass bulkhead female( if I port into PC vessel)
(2) 1/4" male to female ball valves
Pyrex dishes
Electric griddle
1st. I'm gettoing a great deal on a JB eliminator dv-6e 2 stage 6cfm pump rated @ 25 micron...that should work great correct? Any experience or comments? All welcome.
2nd. Should I drill through my 1/2" polycarbonate sheet? Or the pressure cooker vessel?
3rd. Is it OK to use standard 1/4" barbs and polyethylene tubing like from lowes as my purge chamber vac hose? And an inner tube from a bicycle as my chamber lid gasket? Any help greatly appreciated.
Just fyi to get an idea So far I have
Ss baster for tube
1/2" thick 12" x 12" palsun Polycarbonate sheet for vac chamber lid.
IR thermometer gun
*Looking for 400 mesh (50 mic.) Screen 3" x 3" to prevent blow out
PTFE film to blast into & unbleached coffee filters
Hose clamp,
2" oil filled vacuum pressure gauge
1/4" male 50 micron air filter for back filling air in from atmosphere.
1/4" brass 4 way, Teflon tape
1/4" brass bulkhead female( if I port into PC vessel)
(2) 1/4" male to female ball valves
Pyrex dishes
Electric griddle
1st. I'm gettoing a great deal on a JB eliminator dv-6e 2 stage 6cfm pump rated @ 25 micron...that should work great correct? Any experience or comments? All welcome.
2nd. Should I drill through my 1/2" polycarbonate sheet? Or the pressure cooker vessel?
3rd. Is it OK to use standard 1/4" barbs and polyethylene tubing like from lowes as my purge chamber vac hose? And an inner tube from a bicycle as my chamber lid gasket? Any help greatly appreciated.