SmithsJunk
- 3,430
- 263
Nice! A guy I met that presses large quantities said he uses the pucks that are left over to make butter. I got a jar building up in the freezer so I may give it a try.
Thanks. I bought a 5" silicon container to store my pucks. It's airtight, heat resistant, non-stick, and I could probably freeze it as well. I wasn't sure what I was going to do with them but I did at least want them sealed. Also bought a 4" Sharper because my 2.5" grinder was giving me blisters. Can do it in a 5th of the time now and doesn't require such a tight grip. The 4" can grind up to 11g but it's faster to do it 6g at a time. It was really hard for me to drop a 50 spot on a grinder of any sise but the 4" was worth it. I have other brands but none of them cut through flower like my two Sharpers. Anything will due if your just rolling a jay but when your grinding for hours at a time the Sharper's super aggresive blades make life much easier. They cut more than crush and that leaves the chopping chamber with wider spaces between teeth and less resin crushed out to gum it up.
I've started doing blended wax and my extractions for clean e-vape cartridge fills are fully dialed in now.
The cartridge on the bottom was my first attempt. I extracted from an unfiltered puck and it left too much particulate in the juice. The one above was extracted using a 90u nylon squish bag. I also changed over to a strawberry flavored wax liquidiser which covered up the taste of the pg a lot better.
I'm mostly making the cartridges to sell to my co-op's members. I, myself, prefer using an 18" bong with a quartz nail or this quad quartz coil e-mod that's voltage/temp is set specifically for wax dabs. I'm buying an e-jiuce blast tank for it this next week to use for testing on future liquid batches.
Last edited: