GrowChuck
- 8
- 3
I just bought the APC8200 controller, and need so advice!
Basement grow as follows:
Total room size is 12' wide X 13' long w/ single door entry point.
Room is split in half long ways w/2 doors to 2 separate rooms that are appx 5.4' x 6.4'.
Room "A" is Flower with 3 @ 600 watt HSP lights
Room "B" is Veg with 1 @ 600 watt HPS and 3 smaller LED lights
The long room on left side is the work room with a bench, cloner, tea maker, Co2 tank and new controller!
My issue is i just set up the Co2 and Controller, and when i started the Autopilot 8200 both the rooms are reading appx. 850 ppm?
This is WITHOUT the Co2 bottle hooked up to the system? Is there something i'm missing?
What could be causing the Co2 ppm to be that high? That is appx. Twice the normal Co2 level of Air!
Below is a Crude pic of my set up!
ANY Help would be Greatly Appreciated!
Basement grow as follows:
Total room size is 12' wide X 13' long w/ single door entry point.
Room is split in half long ways w/2 doors to 2 separate rooms that are appx 5.4' x 6.4'.
Room "A" is Flower with 3 @ 600 watt HSP lights
Room "B" is Veg with 1 @ 600 watt HPS and 3 smaller LED lights
The long room on left side is the work room with a bench, cloner, tea maker, Co2 tank and new controller!
My issue is i just set up the Co2 and Controller, and when i started the Autopilot 8200 both the rooms are reading appx. 850 ppm?
This is WITHOUT the Co2 bottle hooked up to the system? Is there something i'm missing?
What could be causing the Co2 ppm to be that high? That is appx. Twice the normal Co2 level of Air!
Below is a Crude pic of my set up!
ANY Help would be Greatly Appreciated!