Mold or bud rot on autos

  • Thread starter TheOrganicFarmer
  • Start date
  • Tagged users None
TheOrganicFarmer

TheOrganicFarmer

108
28
Hello people,I've running 5 autos and 2;photos ,i thought this would be a good idea for the space im growing in and by the end if the the auto ill have to good 8 to 9 week vedged photos ready to switch. Due to over foliar feeding or just not enough air flow I've run into some issues,1st issue was some pests 2nd i noticed some cotton candy like mold or at first i thought it was a bug if had on an outside grow that bored into the stems of the body sites and fell off. But I've not noticed that this time. Just some white fluff tight in the main colla. Is their any suggestions on what to do. The autos are nearly finished ,so im thinking maybe just cut the lot down and switch the photos onto flower cycle and can i still smoke the bud from these autos with mold or bud rot on it. Thanks in advance for any help.
 
IMG 20220228 105216
IMG 20220228 105214
IMG 20220228 105200
IMG 20220228 105146
IMG 20220228 105208
IMG 20220228 105209
IMG 20220228 105145
IMG 20220228 104851
TheOrganicFarmer

TheOrganicFarmer

108
28
The 3rd one up is looking a bit poor. It went through my last case, of thrips that was the last plant they moved to. So iv got it under order. It was a genetic freak. This will look more like a small 2to 3 week photo as it was had deformation with leaf growth and side shoot. Well it all grow at the top no side shoots just some odd curry leaves iv had before on blue Berry. Anyway I moved it in bigger pot under a bigger light and within 1 week I had seen a tone of side shouts all growing up so I spayed them out with 2 teqhneques, 1 plastic stem bender and pinching the stem a little just enuf to bend it over give the sides bellow catch up. Then I used plastics stem bender to bend the top out so I get more side shout growing up along with the main growing bk to the way it wants. Check it out. See what you guys think if I'm doing it moderate or is my methods not on point enuf. Thanks again in advance, peace out my organic and non organic growing friends of freedom.
 
sambapati

sambapati

2,174
263
Have you considered running UV/blacklight at least 40 watts 48" T5 or more? That would help you in every respect with killing mold. You could cycle it with a timer or run it 1-4 hours daily. I just finished the last two weeks of flower with 4 hours daily and (so far) see absolutely no mold or mildew just lots of snow. I have 2 dehumidifiers, an ac and air filter and rh @60. Last grow with out UV I threw out a Giant top cola and vowed not to do it again. You can see my grow with the difference before and after. Way more trichomes and no mold so far. Plants now in darkness....before chop
 
AlfaDog

AlfaDog

302
93
Looks like you got botrytis humidity was too high near harvest I had that a while ago when growing blueberry colas where fat and huge and like day and night it was everywhere
 
TheOrganicFarmer

TheOrganicFarmer

108
28
Have you considered running UV/blacklight at least 40 watts 48" T5 or more? That would help you in every respect with killing mold. You could cycle it with a timer or run it 1-4 hours daily. I just finished the last two weeks of flower with 4 hours daily and (so far) see absolutely no mold or mildew just lots of snow. I have 2 dehumidifiers, an ac and air filter and rh @60. Last grow with out UV I threw out a Giant top cola and vowed not to do it again. You can see my grow with the difference before and after. Way more trichomes and no mold so far. Plants now in darkness....before chop
Something I never knew, thanks for that advice, we're I'm from their aren't alot of growers andoney is low so buy weed World bk in the day was the best wee had it,thdn I stop growing for 15 years due to law problems nowi feel I'v that bad heat off me now.
 
TheOrganicFarmer

TheOrganicFarmer

108
28
Something I never knew, thanks for that advice, we're I'm from their aren't alot of growers andoney is low so buy weed World bk in the day
Looks like you got botrytis humidity was too high near harvest I had that a while ago when growing blueberry colas where fat and huge and like day and night it was everywhere
Is that the one with the purple leafed or the one I showed with brittle leaf and brow spot. The resin on top looked dead weres underneath it was still packing gems.
 
TheOrganicFarmer

TheOrganicFarmer

108
28
Here's another 2 tops from this plant, the other 2 largest gave me 1 once now iv got another 2 and few more to finish off in the next 2 days. I'LL PUT UP A PIC of what's left of her carcus lol
IMG 20220301 163722
IMG 20220301 163713
 
IMG 20220301 163720
IMG 20220301 163705
IMG 20220301 163730
TheOrganicFarmer

TheOrganicFarmer

108
28
The 2nd untouched auto the same as the one with the mold is surely gleaming with sparkles and sweet smell. Its
 
TheOrganicFarmer

TheOrganicFarmer

108
28
The 2nd untouched auto the same as the one with the mold is surely gleaming with sparkles and sweet smell. Its
2 top kush strains to combine this lithium kush that nirvana have in their seed collection, I think it OG and MASTER KUSH. makes one fines kush smell and yeild and always enuf gems.
IMG 20220302 130608
IMG 20220302 130646
IMG 20220302 130657
IMG 20220302 130641
 
Stokes

Stokes

379
93
Youve got alot going on. Humidity obviously high, warping of leaves also, thats either over watering or too much N. Could defoliate a bit for better airflow, and for the life of me i dont know why people put other plants in their pots to compete for nutrients. Looks like you may have bugs also?

are you running intake exhaust fans? Pics scream of stagnant air. Real bummer about the mold. I always keep my humidity between 40-50%, but I run in a basement with dehumidifiers so I dont really have to struggle to keep my environment in check, other than in the winter when RH gets too low
 

Latest posts

Top Bottom