2 inch uniseals

[Diysoulgrower]

I can not for the life of me get these horrible 2 inch uniseals to work, they slip through the hole when too much pressure is applied, the holes are the right size, 3". But then they are too tight for the pipe to go through. What gives?

 

[Nugg]

Hey..I went down to tractor supply..and picked up bulkhead fitting...no way I would trust I slip in fitting to hold back water...

 

[MIGrampaUSA]

Hey..I went down to tractor supply..and picked up bulkhead fitting...no way I would trust I slip in fitting to hold back water...

Nugg is right. Those rubber grommets are going to give you grief. Bulkheads are your solution.

 

[Diysoulgrower]

Nugg is right. Those rubber grommets are going to give you grief. Bulkheads are your solution.

I've already started the return and am going for bulkheads, screw this product

 

[Nugg]

From experience...the ones with the thin face..crack super easy...I went with the thick ones after about 20 on the others..hope pic helps ..left side are junk..one in right.. smaller but still the same design as the 2"..

it flipped the pic...the small on is a very good fitting..