Sams0n
- 45
- 18
First. I’m taking instruction from a friend of a friend who grows, and I’ve been watchin a few YouTube videos on cloning and i don’t think my leaves should be yellow on day 4, in a matter of hours.. none but one was yellow this morning. And that one was discolored going in.. I took the top of the dome off today for 15 minutes.. then barely cracked the vent. There wasn’t any roots yet, but I’m sure the leaves weren’t yellow either..
Are these yellow leaves normal, and what do they mean, in regards to the clone, where did those nutes in the leaves go?
I sterilized, cut correctly, and I used clone gelI. I also used rock wool cubes soaked them in Distilled water a very small amount of veg nutes, 1.05oz of this rootbuilder nute. PPM’s were good (I hope) around 375-400, but getting the ph back to 5.5 did put me at around 575ppm. I’ve been worried about that this whole time.
The temperature has been good except one night Day 2 for about 8 hrs it got in the mid 60’s. But heat Mat went in soon as I got it in the mail Day 3. The light is LED 20 watt full spectrum 1800 lumen.
Will they be alright and what do I need to do next. I can’t find relevant videos on what to do besides open the vents slowly. Do I need to resoak the cubes eventually? Come on somebody plz help me.
Are these yellow leaves normal, and what do they mean, in regards to the clone, where did those nutes in the leaves go?
I sterilized, cut correctly, and I used clone gelI. I also used rock wool cubes soaked them in Distilled water a very small amount of veg nutes, 1.05oz of this rootbuilder nute. PPM’s were good (I hope) around 375-400, but getting the ph back to 5.5 did put me at around 575ppm. I’ve been worried about that this whole time.
The temperature has been good except one night Day 2 for about 8 hrs it got in the mid 60’s. But heat Mat went in soon as I got it in the mail Day 3. The light is LED 20 watt full spectrum 1800 lumen.
Will they be alright and what do I need to do next. I can’t find relevant videos on what to do besides open the vents slowly. Do I need to resoak the cubes eventually? Come on somebody plz help me.