lollipopman
- 1,211
- 163
Looking to buy best value vac closed loop system and vac oven. Any one here use them or what is y'all's thoughts on their stuff..
What size system did you buy? Thinking about getting the lb size closed loop with oven..I just bought a passive system closed loop through best value vacs. They have great customer service.
Hey is there a thread for the wait list? LMFAONice. Can I borrow it, fellas?
They do have a great customer support team thou!I've purchased several chambers from them. It maybe quality gear at a decent price, but EVERY chamber I have purchased from them I've had issues with! unfortunately I believe it's mainly due to the way they pack their items to be shipped.
I have there 3 gal wides, they work fine, except one of the gauges is stuck on -5, non of them vac the same ( at least by the reading on the gauge and the time it takes to vac to that pressure), everyone of them have scratches and two of them have some deep ones, and the very last one I picked up has a bent valve..I ran their 3g chamber for years and years w/o any issues. I did rebuild and retape the threads on the air rail. Also bought the sticky mat pid heater.
I'm sorry for the poor explanation,If you unplug a heater, how does the heat go up with no power to make it?
Thank you for the heads up, I must have over looked this in the piece of paper they gave me, it also does this slightlyYes, your supposed to give it a 30 mins for the overshoot temp to level off. It even says that in the instructions. Unless you have a fancy pid like graywolf, most all do this. Even my old rosin plates pid did this. My 1700 1.9cu' vac oven says wait for a 1hr warm up so it levels off the temp.
I double checked the paper work they sent me with the heat pad and it says nothing about waiting for temp to level off, it does say wait 15 min when you're doing the initial offset test with the black strips. Guess I figured that was for it to work itself up to the temp, not flying past set temp then working it's self down. I've never dealt with that with any of my other heating elements, so I was caught of guard.Not that I'm aware of. As with any heating appliance, most of the times there's an overshoot. You just have to give it a 30 min of follow mfg instructions for the temp to level off.
I'd really like a closed loop system! Unfortunately I don't think that it's feasible this is just a hobbie, and make it so I'm able to make my own medication since dispensary concentrates get super expensive..Go through there website and buy it piece by piece you save a small fortune I saved over 1500$ on my 1/4 lb unit