420ReBeLGrower
- Posts
- 182
- Reactions
- 104
- Joined
- Jun 14, 2020
- Points
- 43
Hey Guys,
I have been learning how to LST on this plant and I've been getting better at my watering and so forth. I have a plant that is about 30 days into flower and I've been feeding her better and now want to flush her out before starting the feeding again. I used RO water at 25ppm and Ph'd to 6.0 for the flush. Flushed a 3 gallon pot with around 1.5 gal of water.
Collected run off water and measured . . 500 ppm / 6.8 pH? Why can I not get this PPM to go lower or the pH to drop? I would have though the flush with 6.0 pH would help drop the soil pH to 6.6 or so? Should I be doing something else? The plants are looking good (I had a N def for a bit, but resolved that and after all the leaves that turned yellow fell off, I haven't had any other problems) and I want to keep them that way haha.
I have been learning how to LST on this plant and I've been getting better at my watering and so forth. I have a plant that is about 30 days into flower and I've been feeding her better and now want to flush her out before starting the feeding again. I used RO water at 25ppm and Ph'd to 6.0 for the flush. Flushed a 3 gallon pot with around 1.5 gal of water.
Collected run off water and measured . . 500 ppm / 6.8 pH? Why can I not get this PPM to go lower or the pH to drop? I would have though the flush with 6.0 pH would help drop the soil pH to 6.6 or so? Should I be doing something else? The plants are looking good (I had a N def for a bit, but resolved that and after all the leaves that turned yellow fell off, I haven't had any other problems) and I want to keep them that way haha.