S
Shivaskunk
- 95
- 18
I have inconsistent results thanks I need to wait longer before scraping. Get a chamber I can put my Pyrex in and go from there..
Temps are preferred to be consistent and even, But we dont live in a perfect world do we :p
How long depends on the strain ... how much oil is there.. so many variables. You'll learn after a few 100 runs :p
Take it to full vac tho on earth the highest you can get is -29.9 HG ( if your gauge has a nipple on top CUT IT! ) the nipple should be cut ( Your gauge should be filled with PG if its a decent gauge.. if its reading anything past 29.9 Hg Then your gauge needs replacing..
You can check what sea level your at and see what max HG readout you should be getting.. here in michigan a few 600 feet above sea level i can pull to about -29
Chamber should be heated at alll times during vac, Pull a vac let it sit for a few mins drop the vac SLOWLY... And temp gun the oil and check the temps should be around 110-115 120 is ok but may darken your oil a bit...
When it muffins up to the point its gonna boil over off glass or parchment STOP the vac. SLOWLY release the pressure and let it sit on the griddle more then pull a vac again.. a few times of that and it wont muffin up anymore it will start to fully purge ( or close enuff to it )
keep checking on the size of the bubbles when you notice it stops pulling massive bubbles during vac and only leaving you with little tiny bubbles those are decarb bubbles.. your oil is ready.
Im a typical run i can do an ounce from blast to purge to smoking shatter in less then 3 hours.
once it muffins up stop the vac and allow it to melt back down over your heat source should take about 5-10 mins.. then start again.. repeat this till your done..
and yes just make sure you dont put yer bho on the shiney side ;)
Any ol griddle that you can cook pancakes / bacon whatever on will do.. Presto is a good brand. Mine will go as low as 80 you just have to before the warm line.. it will turn on long before it reaches any of the preset temps on the dial. a TEMP GUN is a MUST!!!! Its really the only way to dial in a griddle.. there cheap .. ebay.. 25$
how you keep it low is by not fucking with the temp dial once you have it dialed it :D
and your welcome its 3 in the morning and i just got up i got nothing else to do :D
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?