Here's how I cleaned my ez cloner for anyone interested,
First I dumped all the contaminated (slime) water and added tap water until it was about 2" from over filling, then I added 3 cups of bleach (i have the 120 unit). I unscrewed all the sprayers and let them sit in the bottom of the bleach water, I did this to ensure there was no slime in the threads. I also had the airlines laying in the res with the bleach. Next I ran the system without the sprayers for 30 min, then I put the sprayers back on and ran the system for 1 hour. Then I flipped all of the foam inserts and ran it for other hour. Next I pulled everything out of the res and scrubbed it down with a new toilet brush, pulled all the foam inserts out and placed them in the res. Next I flipped the top upside down and sat it in the res (this pushes the foam inserts down into the water) and i used the toilet brush to scrub the bottom of the top piece. Then i emptied the res and filled with tap. Then I put the top piece in upside down again to push the foam inserts into the tap water to help rinse out any bleach. After that i put everything back together and ran the system with just tap water for 1 hr, flipped the foam, and ran for another hour. then i emptied the res, dried off the entire outside of the cloner and put a 'damp rid' container within the res to soak up any moisture I could not dry up myself. Then i laid a large garbage bag over the system so no dust settles on it as it air dries, and will store it up later today after it is completely dry.