Delerium
- 783
- 93
20 amp breaker for #12 wire, 30 amp for #10Had a 600 that was tripping a 15 amp all the time. New house has nothing but 30's never trips. Just install the 30 amps and forget about it.
4/0 wire - 350mcm for 200 ampPS, I could run 8 '3 cable for 200 amp box?
Running a 16 light flip box, makes it solo much easier and a lot less wires.gotta say, that powerbox is a badass. :)
flip boxes look cool too. I was pondering those too, but I just have 1 room, so no real reason to flip ballasts, plus was worried about killing them early by never turning them off..Running a 16 light flip box, makes it solo much easier and a lot less wires.
Garage conversion?flip boxes look cool too. I was pondering those too, but I just have 1 room, so no real reason to flip ballasts, plus was worried about killing them early by never turning them off..
Legal, yea you cant beat the pwrbox, it just does so much. Also if you have any ???, they have awesome tech support. Walked me through everything.
Here is one thing to consider. I don't know if you will run into this to.
I don't see a high temp shutoff on your board? When/if you get one, they plug into the trigger override outlet on the right side of box. All good, but here is the problem: The trigger outlet overrides the timer.
So if you have something plugged into the trigger that has current pwr running it will not let you timer work. I solved this by putting my hightemp shutoff on its own pwr strip, plug into a wall outlet through its own timer. I set it to come on 15 min after lights come on & turn off 15 min before lights go out, so the timer is always the exclusive device at the start & end of my 12 hour cycle.
The only other option is to open box (with tech support) and make changes inside, but then the trigger port always has to have 110v pwr going through it for box to work.
I like how clean your look is. I am going to put a board on my wall and clean everything up to. I run (2)1000's and (2) 600's & (1)400 in veg.
View attachment 380354
I don't follow ya boss? Why am I checking numbers? My power box I think will handle all 10 lights with no problem at 4 amps each and 50 amp capacity..?Get your calculator out,then google OHM's Law. Play around with the numbers and you might get a feel for the coralation of numbers and what they mean. JK
I see. I haven't asked a question in a few weeks brother! :)you would understand electrical more and would not have to ask questions and maybe get a bad answer. Knowledge is good when it does not hurt. JK
maybe you were thinking of my older posts.I see. I haven't asked a question in a few weeks brother! :)
Yes. I didn't plan on one either, but it depends on how you cool your room. It only cost like $75 off E-bay, but you can set high temp. In my case I set shutoff at about 95F. means if inside grow room is over that box will shut down. it means for me a fan has failed. I would rater have box shut down then risk what could happen if no air is moving through a 1000 light hood.Now that box looks familiar! Sweet setup reloader. I wasn't planning on a temp shutoff, but maybe I need one...?
Yes , after 15 min if temps are down it will restart. I also have an alarm (T Sentry) that will go off as well.@reloader good idea, would be good to cool the room instead of risk fire.... Does it turn back on then when it cools down?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?