JWM2 said:

I was not able to get VG to mix with PG at all either. Even as low as 10% VG. I make my own e-cig nicotine juice and have for many years so this was not new to me. I also wasted about 1g of BHO (bought). Now I use pressed rosin and pure PG. Heat the PG to 140-160 in a double boiler and let the rosin melt. Stir for a few minutes until its uniform and then inject into CCELL brand carts. I've had great results doing it this way.

Click to expand...

JWM2 said:

. . . Heat the PG to 140-160 in a double boiler and let the rosin melt. Stir for a few minutes until its uniform and then inject into CCELL brand carts. I've had great results doing it this way.

Click to expand...

AnselAdams said:

Ditto! I have found that if you mix no more than 10% of VG with the PEG 400 it will mix well at the 140-180 degree range using the double boiler method as well. I usually keep it at just below 180 for three minutes and the entire time I draw it in and out of a syringe w/blunt needle to maximize contact.

Click to expand...

JWM2 said:

I’ve heard the VG will mix better with PEG 400 than PG. I haven’t had a chance to try it yet so I’ll post my results when I get a chance. But I’m optimistic as I’ve heard others having good results with that mix.

Click to expand...

JWM2 said:

Yeah that’s what I’ve done as well and it seems to work just fine. I figured I’d mess around with PEG 400 to see if it’s any better. So far my tests have shown it’s really 6 in one hand and half dozen in the other.

I’ve heard PEG400 allows for more VG to be used but I’m afraid to try it. Had a bad experience with VG a couple batches ago.

Click to expand...

JWM2 said:

PG works just fine not sure why you have had issues. I tried PEG400 and it was really harsh so I quit using that. Just straight PG for me. I’ve heard you can mix PEG400 with VG but I’m not going to mess with it. Pg works fine for me.

Click to expand...