J
jasonmbrown
- 3
- 1
I have a bit of an issue, in that I didn't expect my plant to grow an extra foot after I switched it to budding phase. Now its right up in the LED grow light im using which burning some of the higher leafs really badly. Its lost at least one perfectly fine starting bud due to all the leaves turning brown. There is plenty of room in the grow tent, since 2 of my 3 plants were males so I had to murder them. Unfortunately I can't raise my grow light any higher and the plant is touching it. Any suggestions?
Currently I have had to move the light to the corner of its tent so its only getting about 1/3 of the plant and the third thats getting the light is also growing pretty close to the light.
Since this was my first attempt at growing, I wasn't sure what to expect when switching from vegetative lighting to blooming. I now know that I need to bloom them at about 2-3 feet as they seemed to grow about 2 feet before they bloom.
Anyway is it safe to bend the tops to stop them from growing any taller at this point? Is there anyway I can get them about half a foot shorter so they are not touching the light anymore without stressing them out too badly.
Its about 2 weeks into blooming phase and they have roughly dime sized buds on them right now.
Currently I have had to move the light to the corner of its tent so its only getting about 1/3 of the plant and the third thats getting the light is also growing pretty close to the light.
Since this was my first attempt at growing, I wasn't sure what to expect when switching from vegetative lighting to blooming. I now know that I need to bloom them at about 2-3 feet as they seemed to grow about 2 feet before they bloom.
Anyway is it safe to bend the tops to stop them from growing any taller at this point? Is there anyway I can get them about half a foot shorter so they are not touching the light anymore without stressing them out too badly.
Its about 2 weeks into blooming phase and they have roughly dime sized buds on them right now.