W
wtjames
- 31
- 0
GH 3 part is great, but I nearly fell off my chair when I saw the 15,10,15 for grow, micro, bloom ratio for mature plants... If that's ml/gal then it's probably around 2500 PPM @ 0.5 conversion and that will fry the shit out of any plant... :shake This ratio that you confidently say "Use this as a base and do let anyone tell you different" is even higher than anything recommended by GH and they want you to use more nutes... Hmmm, I read that you don't use CO2... So what PPM does that mix register at??? Also what is this 6 part as I've never heard of that unless you're counting the supplemental nutrients? :wonderingGH is one of the best, yah alot of people on here say AN<which im sure is good.(but cost a shit load)
GH makes so much great stuff, i use 6 part right no, even with the 3 parts, its works great, ive used it for years and have used there(GH) calculators, and chemist(family memeber).
Use this as a base and do let anyone tell you different(NOT for seeds, or unrooted clones) 10ml micro,15ml bloom,15ml grow.(other 3 for budn) it changes threw the cycle but that< formula will get you haven very healthy weed. 100% for sure.
This is the start formula and its good.
i pull almost 6p off of 12 plants in 60 days of dank, and that was with just the 3 part!
GH 3 part is great, but I nearly fell off my chair when I saw the 15,10,15 for grow, micro, bloom ratio for mature plants... If that's ml/gal then it's probably around 3000 PPM @ 0.5 conversion and that will fry the shit out of any plant... :shake This ratio that you confidently say "Use this as a base and do let anyone tell you different" is even higher than anything recommended by GH and ......
FLORA SERIES™ CALCULATOR
ppm's at user strength
Simply enter the Flora quantities you use to calculate ppm's at user strength. Click here to use the calculator.
Please note: the total ppm is a numerical summation of elements in solution. This number does not correspond to the reading on ppm meters which measure the charge of the elements in solution.
Me too, with a starting tap of 180, 5-10-15 per 2 gallons = 600 ppm @.5.
I usually start at 600 and the peak in week 5 /6 depends on the strain. Peak is anywhere from 1000-1600. In soil, not above 1 k.
I just finished a run with Pure Blend Pro just to get rid of it finally. Inferior product to GH. If you mix and match you can get great flavor.
Well I'll be damned... I stand corrected. :thinking Yep it's 965 PPM on their site. I have no clue what the hell I'm doing then, and I've mixed quite a bit of GH since My first round... Followed their chart to the full strength for recirculating and came up with a much higher PPM and my Hanna is calibrated perfectly... Shit, I'm gonna do that mix and test it on my meter in the next few days to see the light, but I did see this quote on the following page:
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?