Log In Register

Hail Hydro!

  • Thread starter Thread starter PhatNuggz
  • Start date Start date
  • Tagged users Tagged users None

Hail Hydro!

PhatNuggz 335 Replies 43,073 Views
Page 8 of 17 · Replies 141–160 of 336
Awhile back I took a tall male outside. It is now throwing pollen, so I collected some and this morning pollinated one bud on the big plant under the SE 250

It's kinda late as this plant has ~ 3 weeks to go, but I can harvest everything except this branch to allow the seeds to mature
 
Has anybody noticed the burnt leafs?

A grower pointed out that I should have cut way back on the amount of nutes each time I DeFoled. Makes sense

I may also have been using too much CaMg, so I cut that by 50%
 
Last edited:
Another issue that I have been remiss in checking (aside from daily pH monitoring)is: ppm/EC

Where I should be ~ 800- 1000 ppm/2 EC all three rezes were > 1500/3 EC

Either of these could have caused the discolored leafs
 
All rezes drained. Fresh nutes @ ~ 775/1.5 EC.

Probably 2 more weeks then begin flush

Pic 1- 2 SE 250
Pic 3-4 SE 220
Pic 5 SPYDR 600 (these are small Indicas)

IMG 3583
IMG 3586
IMG 3584
IMG 3587
IMG 3585
 
I had to get a few branches that were hanging outside the Cube up into the cube, in order to bring them closer to the light. I tried to be careful with the other branches

The Diesel smell is incredibly powerful
 
Dumped all rezes. Cleaned the pumps housings, filters, air tubing/stones in h2o2

Now flushing with pure water (my ro is ~ 6ppm). Fresh nutes will be added later

P 1-2: Note the purple in the leafs on plant under the SE 250. She has a heavy Diesel smell. She is close, maybe 7-10 days left

P 3 Indica under the SPYDR 600

P 4-5 Sat dom under the SE 220. Note the bud growth down low (post DeFol), way more than under the SE 250. Go figure. Benefit seems to be somewhat pheno dependent
 

Attachments

  • IMG_3592.JPG
    IMG_3592.JPG
    335.5 KB · Views: 160
  • IMG_3593.JPG
    IMG_3593.JPG
    190 KB · Views: 161
  • IMG_3589.JPG
    IMG_3589.JPG
    281.6 KB · Views: 156
  • IMG_3591.JPG
    IMG_3591.JPG
    231.1 KB · Views: 157
Turned off the CoBs yesterday afternoon on the SE 250, as she is close to finished. My thinking is less light will trigger her to push out anything that's left before harvest

Note the purple in the upper leafs. Strong Diesel smell.

Best is, I have 3 clones that are almost 3ft tall. Also, might have some seeds from a couple buds that I pollinate with a tall sat male from the same seeds

The other sat is doing well under the SE 220, with lots of quality bud down low, due to opening up the canopy by DeFoling. What I don't know is whether she is taking longer due to the SE 220, or simply her pheno
The indica (under the SPYDR 600) is small, but no doubt will be very potent

IMG 3594
IMG 3597
IMG 3598
 
I turned off the SE 250 light over the Diesel. I will leave her in the dark for 48 hours (continue t flush with < 200ppm water) then harvest
 
I just finishing dumping nutes in clone tent. Man, they were out of whack.

All 3 are over 3 ft tall and more than ready to move into the main tents. Alas, those plants aren't quite ready
 
I harvested the diesel from under the Amare SE 250 (300w)

700gms wet trimmed

173gms of Larf, which is mostly small leafs due to DeFoling a month ago

Tomorrow I will be harvesting te indicas under the BML SPYDR 600
IMG 3607
IMG 3609
IMG 3610
IMG 3611
 

Attachments

  • IMG_3612.JPG
    IMG_3612.JPG
    243.9 KB · Views: 147
I harvested and trimmed both of the Indicas that were under the BML SPYDR 600 (~ 330w)

Since they were same strain/pheno (although one was < half the size), I will provide weights as one

~ 600gms wet trimmed. I forgot to weigh the rest of it (see pic of mostly harvested plant)

Cleaned the totes, now need to make transition nutes to move 2 plants from clone tent
 

Attachments

  • IMG_3613.JPG
    IMG_3613.JPG
    138.4 KB · Views: 139
  • IMG_3615.JPG
    IMG_3615.JPG
    162.1 KB · Views: 139
  • IMG_3618.JPG
    IMG_3618.JPG
    215.5 KB · Views: 140
Final plant Sat from the SE 220

483 gms

I did not weigh the trimmed leafs which were uber sticky and will make some fine oil

The pics of what was left on the plant is to show how much bud there was down low, due to DeFoling twice, which also contributes to sticker larf 98gms.

IMG 3620
IMG 3621
IMG 3624
IMG 3623
IMG 3622
 
Whew, just finished cleaning the SE 220 tent, the tote, the stones and moved one diesel clone from my bubble clone tent to the SE 220: the other clone under the SE 250 has perked up, so all ahead full.
 
The 2 Diesel clones were kept way too long under ~ 60w white led, and stretched quite a bit. However, they have adapted quite well to their new much brighter and more intense homes (220/250w).

Lots of new leaf development.

The plant on the right (SE 250) was moved maybe 10 days ago and already has a bunch of pistil/bud sites developing.

The plant on the left (SE 220) has only been under the SE 220 maybe 5 days

For some reason upload photo not visible
 
SE 250 Final Weight (buds only) 168gms

(I previously gave my biz partner a top snapped branch to cure and enjoy)

SE 220 needs a bit more drying

Still unable to grab pictures. WTF?
 
Do you have an "Upload a File" tab in the reply box? What exactly is happening? Let me see what happens when I attach.

991277 atgatt
 
Sometimes there are random days my phone won't upload. I just figure it happens sometimes.
 
The Upload tab has not been there. will try now...

Nope, just Reply to Thread or Preview

I tried to post a pic in another thread. When I hit more options I briefly saw the Upload a File but it quickly disappeared. WTF?

Just now I see the More Options, but when I click on it it does not take me there. Instead, I only see Save Changes and Preview
 
Last edited:
Page 8 of 17 · Replies 141–160 of 336
Back
Top Bottom