Hello everybody

Lilolme · Feb 13, 2020

The girl in the tub is lovin it, I tweaked my lights. I flipped the cooling fans over and removed the vent material covering the fans. The air now enters the sides and out the top instead of the other way around they run much cooler and I can add hose adaptors to vent the heat for summertime. I like the load stabilizer bars its a quick easy to have a strong hanger for my lights without fastners. As long as they fit the space and the walls are fairly sturdy.
2 Pack 86-104 Inches Long Heavy Duty Steel Load Lock Jack Bar Freight Tie-Down for Enclosed Trailers, Reefers, and Cargo Vans ...... https://www.amazon.com/dp/B07C5YD5R4/ref=cm_sw_r_cp_api_i_cgyrEb92XQ6NV

Sonnyhad · Feb 13, 2020

Nice lookin plants !

Lilolme · Feb 13, 2020

Sonnyhad said:
Nice lookin plants !

Thanks

Lilolme · Feb 14, 2020

Lilolme said:
The girl in the tub is lovin it, I tweaked my lights. I flipped the cooling fans over and removed the vent material covering the fans. The air now enters the sides and out the top instead of the other way around they run much cooler and I can add hose adaptors to vent the heat for summertime. I like the load stabilizer bars its a quick easy to have a strong hanger for my lights without fastners. As long as they fit the space and the walls are fairly sturdy.
2 Pack 86-104 Inches Long Heavy Duty Steel Load Lock Jack Bar Freight Tie-Down for Enclosed Trailers, Reefers, and Cargo Vans ...... https://www.amazon.com/dp/B07C5YD5R4/ref=cm_sw_r_cp_api_i_cgyrEb92XQ6NV View attachment 940642 View attachment 940643 View attachment 940644 View attachment 940645

You can clearly see in the description these are for reefers too

Lilolme · Feb 14, 2020

I tried an experiment on a branch that was much taller than the rest. Took a fuel line clamp off tool and used it to crush the stem on the inside of the bend while not harming the other side. The branch just relaxed and laid over. Supported a little and off we go. Looked good this mornin the branches are already reachin for the lights

Lilolme · Feb 18, 2020

gettin stinky and sticky at about 3 weeks flower

Lilolme · Feb 21, 2020

Up to 550 ppm ph is runnin pretty steady 5.7-5.8. Discovered she likes the reservior a little lower below the net pot. Still usin the GH nutes very carefully along with a little Flower Fuel. Bubba Cush 3 1/2 weeks in flower

Lilolme · Feb 21, 2020

The runt has been in veg for 9 weeks. She is finally comin around gonna flip the timer today. She has been on flower nutes for about a week and is itchin to make buds, I hope

Lilolme · Feb 21, 2020

Forgot to add that the branch I intentionally broke is healin fine and is tryin to stand back up I had to tie it down

Lilolme · Feb 23, 2020

I hate this when things are at this point, gooey fingers

Lilolme · Feb 24, 2020

And of course now the humidity is droppin, I have a humidifier but haven’t had to use it for quite a while. 29% this mornin. Been runnin a small electric heater at night when the lights are off to keep the big temp swings in check. Oh the humanity

Lilolme · Feb 24, 2020

oldskol4evr said:
looks like your doing fine to me ,like your setup,welcome to the farm friend

I apologize for not thanking you for welcoming me!

Lilolme · Feb 24, 2020

Checkin my ph meter, its new this grow but I use it often. Read 6.7 in my 7.0 reference solution so I went through the calibration process which I have never done. Was pretty straightforward I only had to purchase distilled water. I use the ppm scale on my tds meter although it will also display tds. A question, my last res batch went in at 600 ppm and I have only been toppin off with water. Its down to 450 or so now and my ph has been running pretty consistant in the good range. The leaf tips got the tiniest burn since the last batch which was the highest ppm it has has, its barely noticeable. Wondering when I should plan a res change this ones a week old temps are runnin in the 60f range. 3 ish week into flower

Lilolme · Feb 24, 2020

By 60f range I mean 65 plus or minus a little.

Lilolme · Feb 26, 2020

4 weeks into flower, shut off the lights for a couple of pics of not the best quality. Will have to use a handheld light with a 100 watt incandescent bulb as the flash doesn’t do them much justice. Ppm up to 650 now maybe by the time she’s ripe I will have a handle on my nutes and a good schedule to go by.

Hidd3nGr0w · Feb 26, 2020

When this finishes its going to be epic. Looking good @Lilolme

Lilolme · Feb 26, 2020

Hidd3nGr0w said:
When this finishes its going to be epic. Looking good @Lilolme

Thanks! Gonna try a couple back to back grows and pay closer attention to the next one. Also have to find a forum to hang out in. I got almost enough to last me 2 years off of a previous attempt it was larfy as hell but I had let the trics get way amber and purple, 12 weeks in flower it would just about put you in a coma

Hidd3nGr0w · Feb 26, 2020

Roflmao! First plant I grew was like that. I let it keep going and going till it had an orange hue to it. Smoke a joint and go right to sleep with it still burning in the ash tray.

Lilolme · Feb 27, 2020

The runt in the bucket has been doin pretty good, she put on a real nice stretch and is a few days into flower. Again faced with all the tall top growth and, for now, limited options for tyin her back I decided on the controlled break of the branch, exactly where I wanted and in the direction I wanted. I just pulled it down and let it rest on the lower growth with no support. If it behaves like the other branch I tried this on I will have to tie it down in a couple of days. Soon she will sit on a rolling rack I built with unlimited tie down options and I can begin the bondage.

Lilolme · Feb 28, 2020

I know goin hermie happens but shemale?

Hello everybody

Hello everybody

Lilolme

Sonnyhad

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Lilolme

Hidd3nGr0w

Lilolme

Hidd3nGr0w

Lilolme

Lilolme

Privacy & Transparency

Privacy & Transparency