S
savemybudz
- 9
- 3
One of my dual hps/mh bulbs burst, apparently caused an electrical arc (still dont know what exactly happened) and MELTED my 4x8 tray and damaged the table it was on (flood and drain setup). The entire grow room got coated in ash AND due to the nature of the ac system setup, ash got all over my other room that is flowering in 2 weeks. I managed to use a shop vac to blow the ash off of all the buds and there is still a little bit of ash on the about to flower buds where it was most sticky. Just wondering if you guys had any advice with this scenario and what you would recommend. Thank god my entire block didnt burn down, remember to use high temp cutoffs, they saved my life!!!!!