Z
zipflip
- 122
- 0
ur talkin correct guage size, right? idk as of yet wat guage is needed for 30 amp. im just now starting on this after havin it on my todo list for some time now lol.hey zip...be sure when useing cords they are large enough for the 30 amp
not sure wta you mean but there are 2 electric baseboard style heaters that havent worked for bout 100years lol, and few months back i had to flip a breaker that clicked on me once and i figured i'd map out my breaker box and see wta all went where yada yada, and found that i got a 30 amp breaker taht has only the 2 electric heaters on it which havent worked forever so i finger , hey. perfect for my grow if i can tap it some how. cuz i been stringin ext chords to date yet. and it bugs me , somethin fierce. lol..is this the only power oing into the room? if so ya can get a stacked 30 AMP which would give ya two seperate brakers.
again im not sure i understand wat ya mean , man. lol . im clueless when it comes to this sorta thing.not sure if ya know how ya wire from the breaker to the room...I seee ya have help with a heater..have ya got the 30 amp wire connected in the panel?
i know and understand wat ground means and is but the "neutral" gets me ,? what is the neutral? is that for the third prong on most all grow equipment chords/plugs? is there anyway a person can set up a ground and neutral if need be then?There may not be a ground at the thermostat, and no neutral either. Most timers would need a neutral and you definitely need a ground for your equipment...
jus disconnect wires goin to heater in the wall and just reconect them wires to a new outlet , right?just remove the Heaters and install a remodel box for outlet at this location..you can lay the remodel box sideways..
well, upon my further reading and watchin online vids on breaker changing and installation etc etc i think/feel cool wit attemptin the whole breaker installation thing.You have at your disposal 2 20 amp breakers (you can remove the clip so they act independently). Your SAFEST route would be to disconnect and remove the heater feeds at the panel and run two 12/2 lines @ 20A each to your room: or a 3/12 into your room then branch to 2 individual circuits.
Cheers
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?