Log In Register
  • Thread starter Thread starter TomThumb4000
  • Start date Start date
  • Tagged users Tagged users None

LED light has a dim glow when turned of. Please help

TomThumb4000 5 Replies 320 Views
Page 1 of 1 · Replies 1–6 of 6
1
T

TomThumb4000

Posts
3
Reactions
4
Joined
Sep 8, 2026
Points
3
Iv got a 700 watt LED light, when its turned of ( with or without timer ) the right hand side of the light stays on, its only a very dim glow but still on, has anyone els had this problem ?

Cheers, Tom
 

Attachments

  • 20260907_222112.jpg
    20260907_222112.jpg
    200 KB · Views: 5
Iv got a 700 watt LED light, when its turned of ( with or without timer ) the right hand side of the light stays on, its only a very dim glow but still on, has anyone els had this problem ?

Cheers, Tom
hopefully someone chimes in to help you out,.
i’m old school and use metal halide and high pressure sodium lights,..
 
hopefully someone chimes in to help you out,.
i’m old school and use metal halide and high pressure sodium lights,..
Aparently the mains has a slight eletric leak, i THINK a ecotechnics powerstar 1 way contactor should fix it i hope but im slightly stressing out lol
 
Hi @GNick55 I had the problem too.
I just sent my lamp back to the manufacturer.
Usually it's the driver or the dimmer that is connected incorrectly.
 
This problem isn't unusual apparently there's 2 main reasons, #1 residual power in the circut in which it's only temporary it'll go out after a bit time?
Or the wiring is back to front somewhere and the power switch is disconnecting the neutral instead of the live allowing a bit current to get through, normally the switch cuts the live.
I've got a light controller that keeps the chips illuminated after turning off for 5/10 minutes
 
This problem isn't unusual apparently there's 2 main reasons, #1 residual power in the circut in which it's only temporary it'll go out after a bit time?
Or the wiring is back to front somewhere and the power switch is disconnecting the neutral instead of the live allowing a bit current to get through, normally the switch cuts the live.
I've got a light controller that keeps the chips illuminated after turning off for 5/10 minutes
Got a contactor and its solved the problem
 
Page 1 of 1 · Replies 1–6 of 6
1
Back
Top Bottom