pretty sure i still see it on your plants..Looking for any guidance on steps to take on this if the mold returns. So far I’ve cut everything off that had anything that looked like this. Going to check daily for returning mold. So what is one to do. I’ve heard hydrogen peroxide is a solution and a last ditch effort to save would be a burn sulfur which will make it taste bad.
Yea this was before I trimmed it all off. Was just showing the before pic. What’s a good ratio of peroxide to water?pretty sure i still see it on your plants..
i’d spray with a 3-5% strength mix of hydrogen peroxide and water, let sit after spraying for 5 mins than i’d crank the fans on high like a wind storm for 30 mins at least, i’d even spray the inside of the tent/floor..
even at harvest wash the buds before drying/curing..
wpm is evil, can spread easily to other plants and can survive very easily for a long time, so a major!!! clean up is needed after the grow is finished..
Fox farms ocean forest. I mean how much water do I mix with the 3-5% peroxide? Like 1 part peroxide to 2 parts water or 1:1?say about 3-5% strength and soak everything, but what’s your growing medium?
ok i buy 29% strength h2o2 and mix it down with water.Fox farms ocean forest. I mean how much water do I mix with the 3-5% peroxide? Like 1 part peroxide to 2 parts water or 1:1?
Thank you!ok i buy 29% strength h2o2 and mix it down with water.
have to find a stronger strength you can mix down and good to get at least a one gallon jug.
i’d also cover the soil with something to prevent the h2o2 mix from getting in there.
Yea I’m dumbfounded. I have two fans blowing on top and one underneath and my RH is never above 50%(my personal preference to avoid this. Also a 6 inch inline on full blast.It's a herbicide at 12%. I wiped out some PM covered weeds outside with just that. The PM fizzed, and the plant seemed fine the next day. A couple more days, and I realised it had in fact killed it. As it should of.
I say this as a guide to what you might get away with.
PM is everywhere. The fact it can grow on your plants, indicates a different issue. Generally RH and airflow concerns.
I don’t think so. I have three other tents in the same room and no issues with them. So far this was my most successful grow without any issues. Something was bound to happen lol. Hopefully it doesn’t comeDo you think your air is a bit gammy? Carrying in some organic gunk that's on the leaf, feeding the PM.
I can't induce it with RH or poor air. I just get rot. It's only in cellars where I ever had PM indoors. Where you could smell is wasn't right anyway.
Yea now that I think of it it could have been from my outdoor grow. Had some PM and I was in the shed closing my pool and could have tracked it in. I sprayed them good last night. Nothing new today but will definitely continue to spray and hopefully save all of the productyou’ll more than likely have to give them a good h2o2 spray every 4/5 days till finished, than i’d wash the branches/buds in a h2o2 bath before drying.,
the culprit could of been you bringing it inside from an outdoor grow, or a friends grow, or a friend, pet brought it in, it just didn’t appear indoors because of humidity or airflow… it’ll thrive in those conditions but are not the cause.,
the plant will be infected at least 2 weeks before the white stuff appears on the leaves.
wpm can live on a speck of dead plant material for over a year!
so clean clean!!
My humidity is always running lower. It usually around 50. I’ve figured it was from me bringing it in from outside. Hoping it stays gone.It's really dry this time of year are u using a humidifier? If so turn it off or keep as far from tent as possible.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?