pdasterly
- 329
- 43
i read that as well, smallest pump that will work is 250gpm, thats smallest inline pump i can source, ecoplus and active aquaSince you're working with such a small amount of water in a relatively powerful chiller, I'd consider adding a percentage of food grade glycol. Especially if you're going with a smaller pump.
current system uses 1000gpm pump and travels approx 30 ft, using 1" hose. I just hate when the chiller gets clogged, its unexpected and annoyingThat's quite a length of 1/2" to be running off a 250. The faster the flow, the safer you'll be.
idk im open to ideas, havent pull trigger yet, but soon after harvestWould it not be better to have a seperate res for the chiller to cool than pump that chilled water thru the wort chiller? Seems going from 1in to half in is going to reduce the flo by half. Seems like a bad idea to go out chiller into coil. You would be able to use the chilled res to cool more stuff if u used big enough res.
Im going to be cooling 3 ucxl32 systems with 3 50' ss wort chillers ran off a manifold and return manifold. 1 1800 gph danner mag feeding the manifold and a 1200 danner mag pushing water from my 200 gallon res thru chiller to chill the 200 gallons.idk im open to ideas, havent pull trigger yet, but soon after harvest
pics please, my brain cant visualizeIm going to be cooling 3 ucxl32 systems with 3 50' ss wort chillers ran off a manifold and return manifold. 1 1800 gph danner mag feeding the manifold and a 1200 danner mag pushing water from my 200 gallon res thru chiller to chill the 200 gallons.
Dont have yet. Its in the works. Googlemanifole for chillong multipme res with one chillerpics please, my brain cant visualize
Those are wort chillers. Give me couple days and ill have manifold setup finished. Its only the 2nd one ill have built and lts a headache. Sit down and draw it out on paper to figure out the pieces. Use shutoff valves not sure what would be better on the return or the feed side but adjust to get equal pressurepics please, my brain cant visualize
i got my coil from nybrew, was gonna use a 13 gallon bucket and put pump inside bucket. So return line from chiller to coil, out coil into the bucket. The pump stays under water inside the bucketAs far as running water thru your chiller then into the wort then back to chiller. You will probably damage the chiller because not enough flow rate.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?