Flipped these 2 girls 2 weeks ago and feeding the TA dual part Coco plus 1ml/L of canna cal-mag. Medium is Coco and around 20% perlite. I've tried only the nutrients with no cal mag and had issues during veg, so shouldn't be an excess of cal mag.
My feeding ATM is between pre bloom and bloom. 2.5ml/L of each grow and bloom (label recommends 3ml grow and 2ml bloom in preflower and 1.5ml grow and 3ml bloom). Would this ratio be appropriate for 2nd week after flip?
Rough numbers are: Base water 100ppm + 800 nutrients + 200 cal mag. It doesn't really go over 2.2EC
My vpd although not too stable I try my best to leave at an acceptable range around 25c and trying to keep 60% and under.
(They are wet cause they were sprayed h2o2 just before the pic)
So I was away for 6 days and the burnt have progressed a bit in the past week, I'm now feeding 2 parts Micro, 1 part grow and 3 parts bloom with around 200ppm calmag totalling around 1100 ppm.
I've just started cutting grow and increasing bloom last week and the scorched edges shown on older and bigger leaves, young ones seem fine.
Any suggestion whether to re add a bit of the grow or how to best adjust to this stage? She seem to be done producing the initial pistils and will now start growing the actual flower.
Flipped these 2 girls 2 weeks ago and feeding the TA dual part Coco plus 1ml/L of canna cal-mag. Medium is Coco and around 20% perlite. I've tried only the nutrients with no cal mag and had issues during veg, so shouldn't be an excess of cal mag.
My feeding ATM is between pre bloom and bloom. 2.5ml/L of each grow and bloom (label recommends 3ml grow and 2ml bloom in preflower and 1.5ml grow and 3ml bloom). Would this ratio be appropriate for 2nd week after flip?
Rough numbers are: Base water 100ppm + 800 nutrients + 200 cal mag. It doesn't really go over 2.2EC
My vpd although not too stable I try my best to leave at an acceptable range around 25c and trying to keep 60% and under.
(They are wet cause they were sprayed h2o2 just before the pic)