Tchever1 said:

Have a number of older Fluence 8 bar Spyders. Keepin them alive is an adventure for sure. Have had success with Mean Well drivers to replace originals however, jus wonderin if anyone has experiance rebuilding diode bars? Parts and proceedure advice greatly appreciated

Click to expand...

Imzzaudae said:

I have been around electronics repair all my life. You would need a good soldering station. A solder vacuum and a lot of patients.
It could likely be done if you can find replacement diodes. It would not hurt to practice removing components from junk electronics first so you don't over heat the good boards.

Click to expand...

Imzzaudae said:

I have been around electronics repair all my life. You would need a good soldering station. A solder vacuum and a lot of patients.
It could likely be done if you can find replacement diodes. It would not hurt to practice removing components from junk electronics first so you don't over heat the good boards.

Click to expand...