New Mammoth controller setup has me stumped

[FlatheadFisherman]

Recently picked up the Mammoth controller for the 10 bar with UV and far red and the directions are of very little help. I’m not very tech savvy and I’m struggling trying to program it.
I did try to call Mammoth, but they weren’t much help. Searched for any videos on how to, and came up empty.
Hoping someone might be able to help an old head out.

 

[BoogieGrown]

you are correct the instructions are not that great that come with it…I just played with it a bit and tried reading the controller manual to the best of my ability. I don’t use the sunrise/sunset option and switched my output signal to PWM

Lots of trial and error my friend…gotta hit that checkmark box too after you make changes I think. Keep going over the manual while you play with it. Personally I like it in dimming mode as opposed to spectral mode. You can change this by holding where it says “ grow light controller” for a few seconds

I’ve included a picture of what my flower light schedule is…if anyone else would like to help out that would be greatly appreciated as I am new to IR/UV myself and really don’t know what the hell im doing with it

 

[BoogieGrown]

Looking at this picture from what they are now that red makes em stretch…I think I’ve had these in for a week and they are way taller now than this picture shows

 

[BoogieGrown]

After 10 days of supplemental IR…3 of which are flower light schedule

 

[BWKSGROW]

So I just recently bought the mammoth 10 bar series with the TV and the controller and i'm not tech savvy either i was wondering if you had it anymore tips or advice on how to set this up