AnselAdams
Supporter
- 1,262
- 263
They seem sincere but mods tell a different story, i am not saying anyone is right but this is just trolling, a cheap trick to do. Then again who doesn’t have a delusional ex :D
AMEN! been there, done that!
They seem sincere but mods tell a different story, i am not saying anyone is right but this is just trolling, a cheap trick to do. Then again who doesn’t have a delusional ex :D
Ol' faithful. Need to get her set back up.
This is a prebuilt system, brand called subzero. Had one system I built with a buddy a while ago but we sold that off, wasn't exactly the best quality.
4lb column, depending on material. Was 1750 to build not including braided hoses, condenser coil, solvent tank. Cost pretty much only dry ice/denatured alcohol slurry, also very little butane left in shatter platter for pour off. So may be 40 to 50 bucks per run, running cold injection. I use the jacketed column if material is iffy or want to make sauce. Percents for me range from 9% for trim to 18% for great nugs. Just always depend on material, with a system this size, a couple runs pays it off.Do you mind sharing your ballpark cost; avg. input material weight and your avg. output numbers? Your size appears to be where I want to go. By then i will have retired and relocated and want to be able to support our habit and income by being able to sell into the retail market.
Thanks
...
I let it sit at full vac for 12 hours. Started at 110 degrees for about 2 hours then to 120 for the duration. At 12 hours I was able to touch it without it sticking to me, so I formed the patty and put back in the vac and will check after another 12 hours.
...