BirdLaw86
- Posts
- 296
- Reactions
- 427
- Joined
- Oct 18, 2021
- Points
- 63
Ive been counting lol. Zoom in and youll see the others about to sprout up.
Thanks for the tips, I always have a few stragglers around to play with, so will give that a go! I've always wanted to try main-lining too, but recently just started doing SOG and dont do much to them since they don't veg that long. But always looking to improve my garden and golf score, FORE!!!Make sure to not over do it with the LST and defol cuz it stresses her out but you can take off a decent amount. My suggestion is to tie her down and wait like 2 days and then youll see new flower sites, once you see those youll see fan leaves that are big as shit and will be blocking the new growth from the light. Take a few minutes and look closely at which leaves are most important to remove to open the canopy. Leave the ones which dont need to be removed. Go back after 2 days and secure the ties down a bit more, i actually move the place its tied on branch and keep moving the tie towards the tip of the branch leaving about 1.5 inches above the tie but BE CAREFUL WHEN DOING THIS, DO NOT SNAP THE TOP AND DO NOT SECURE THE TIE ON ANY PART OF THE NEW SPROUTS LEAVES, in other words make sure the tie is secured to the branch without it touching the newly sprouted growth. Hope that helps.
goddamn that's a fuckin slab of shatter man lolweighed 64g's! didnt realize how thick it was gonna end up but no complaints so far
nice, i don't make shatter but one thing that applies to anything that is being poured is that you want to give it small little taps on the side of the area or from the under neat and that would remove all the air bubbles. Goes same with doing concrete.weighed 64g's! didnt realize how thick it was gonna end up but no complaints so far
I'm sure a bunch! Quick run down is justHi guys is there a thread somewhere regarding making shatter?
Awesome i have a lab grade vacuum which i could use.I'm sure a bunch! Quick run down is just
1) blast a tube with butane into pyrex
2) hot water bath the pyrex dish to thicken up the solution
3) put it on parchment paper
4) place into a heated vacuum chamber for a day until its purged
Just remember low temps make shatter so start at 90ish!
oh yeah! lol you can get a dab rig (essentially a wax bong) to smoke it or roll up a thin snake and put it in a joint... that's my wife's favorite! Keep me posted on that projectAwesome i have a lab grade vacuum which i could use.
What does shatter taste like, does it mess you up like mega super duper ripped?
Oh and thank you for the tips!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?