JWM2
Premium Member
Supporter
- 3,806
- 263
Have you used your oxycloner? You have one right?View attachment 852283
It’s only been a couple hours but here’s a closeup of UC1. UC2 is still under the soil and is to be expected as it’s tap root was 1/3 of the size of UC1 and was buried slightly to allow it to break the surface on its own.
I have. I recently quit using it as it was taking too long to root the cuttings. I ended up grabbing some domed propagation trays for another project and used them with rapid rooter plugs and clonex and had roots in about a week to 10 on every cutting taken. So it’s just easier to not mess with the oxy cloner and do this instead.Have you used your oxycloner? You have one right?
I’ve had mine in for a day so far in oxycloner we will see :)I have. I recently quit using it as it was taking too long to root the cuttings. I ended up grabbing some domed propagation trays for another project and used them with rapid rooter plugs and clonex and had roots in about a week to 10 on every cutting taken. So it’s just easier to not mess with they’ve hl oxy cloner and do this instead.
Looking good. How big are the pots in the bottom and how big are the pots in the top. How long do you veg to grow with room in your rack?
Thanks for the info I just saw your review on the oxycloner on amazon lol. Good info. I’m about to switch air stones or something to try get more mistPots in the bottom are about 1/4-1/2 gallon. I grow them to about 12-14” and then transplant them into 3 gallon pots that go into the flowering chamber above. The plants above get to about 24-26” above the soil when finished. I top them if they start stretching too much to keep them away from the quantum board lights.
Been getting around 2-2.5 oz per plant every 8 weeks depending on strain at a cost of between $6-10/oz to produce including the cost of electricity, soil, nutes, etc.
The genetics I don’t factor in as that’s a one time cost for seeds and then I clone them from that point on so they don’t cost me anything but a rapid rooter plug to reproduce.
I grow perpetually so I’ve always got something going in and coming out. I’ve got this last round bunched up a little. Should have a decent harvest mid feb to end of feb and then nothing for a few weeks until the middle of March. I may end up putting a couple more plants in flowering as I have room for 10 but currently only have 8 in there. But if needed I can add a couple more.
I also have 2 gallon flowering pots but those require frequent watering mid to late flowering so I don’t use them anymore unless I’m testing out new strains and want to flower them early to cram more of them in a smaller space.
Ive done this also. Just put the cuttings in a cup of tap water. Had good success rates. I also use an oxy cloner. I have no complaints about it. Although I would recommend putting it on a timer for 15 minutes off 15 minutes on so the pump dont get hot.I’ve had good luck with homemade dwc cloners in the past but right now it’s just easier to go another route as it takes up less space and seems to work in 1/2 the time. At one point I cloned in solo cups full of tap water so I don’t need anything too complex to accomplish the task.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?